이 페이지는 자동 번역되었으며 번역의 정확성을 보장하지 않습니다. 참조하십시오 영문판 원본 텍스트의 경우.

Effect of Different Adhesive Removal Techniques After Orthodontic Bracket Debonding on Postoperative Hypersensitivity: A Randomized Clinical Trial

2026년 11월 9일 업데이트: Asmaa Badr Abdelfatah

The objective of this randomized clinical trial is to evaluate and compare the effect of four different residual adhesive removal techniques following orthodontic bracket debonding on postoperative tooth hypersensitivity. The study compares low-speed tungsten carbide burs against fiberglass burs, white stone burs, and rubber-impregnated polishing points. Postoperative hypersensitivity will be evaluated using a Visual Analogue Scale (VAS) with an air-blast stimulus test immediately after debonding, at 24 hours, and at 7 days follow-up.

연구 개요

연구 유형

중재적

등록 (추정된)

15

단계

  • 해당 없음

연락처 및 위치

이 섹션에서는 연구를 수행하는 사람들의 연락처 정보와 이 연구가 수행되는 장소에 대한 정보를 제공합니다.

연구 연락처

연구 연락처 백업

연구 장소

      • Cairo, 이집트
        • Faculty of Dentistry, Cairo University

참여기준

연구원은 적격성 기준이라는 특정 설명에 맞는 사람을 찾습니다. 이러한 기준의 몇 가지 예는 개인의 일반적인 건강 상태 또는 이전 치료입니다.

자격 기준

공부할 수 있는 나이

15년 (어린이, 성인)

건강한 자원 봉사자를 받아들입니다

예

연구 대상 성별

모두

설명

Inclusion Criteria:

  • Patients of any gender aged 15 to 45 years undergoing routine fixed labial orthodontic bracket removal across anterior and premolar teeth in both jaws.
  • Systemically healthy patients.
  • Good oral hygiene with a healthy, intact periodontium without clinical attachment loss or gingival recession.
  • Patients capable of reliably recording subjective discomfort on a Visual Analogue Scale (VAS) and willing to attend follow-up visits.
  • Sound fully erupted permanent incisors, canines, and premolars bonded with conventional stainless steel labial brackets.
  • Labial enamel surfaces free of visible pre-existing enamel defects, structural hypoplasia, severe fluorosis, or restorations.

Exclusion Criteria:

  • Active use of systemic analgesics, NSAIDs, corticosteroids, or centrally acting pain medications within 14 days prior to debonding.
  • Use of desensitizing toothpastes, mouthwashes, or topical fluoride varnishes within 30 days prior to the trial.
  • Heavy bruxism, clenching habits, or pathological wear/erosion extending into dentin.
  • Pregnant or lactating female patients.
  • Teeth with irreversible pulpitis, pulpal necrosis, history of endodontic treatment, or periapical pathology.
  • Teeth with active carious lesions or exposed cervical dentin/cementum.
  • Teeth with severe, deep enamel microcracks identified at baseline examination.

공부 계획

이 섹션에서는 연구 설계 방법과 연구가 측정하는 내용을 포함하여 연구 계획에 대한 세부 정보를 제공합니다.

연구는 어떻게 설계됩니까?

디자인 세부사항

  • 주 목적: 치료
  • 할당: 무작위
  • 중재 모델: 병렬 할당
  • 마스킹: 더블

무기와 개입

참가자 그룹 / 팔
개입 / 치료
활성 비교기: Active Comparator: Low-Speed Tungsten Carbide Bur

Residual composite adhesive remnants on eligible teeth are cleaned using a 12-fluted low-speed tungsten carbide bur operated at 15,000-20,000 rpm under continuous water cooling.

Composite resin is removed using a 12-fluted tapered low-speed tungsten carbide bur operated at 15,000-20,000 rpm under continuous air-water spray irrigation until all visible adhesive remnant is completely eliminated.

실험적: Fiberglass Bur

Residual composite adhesive remnants on eligible teeth are cleaned using a fiberglass bur operated at 15,000-20,000 rpm under continuous water cooling

Composite resin remnants are eliminated using a fiberglass resin-removal bur operated at 15,000-20,000 rpm under continuous air-water spray irrigation until all visible material is completely removed.

실험적: White Stone Bur

Residual composite adhesive remnants on eligible teeth are cleaned using a fine-grit white stone bur (aluminum oxide) operated at 10,000-15,000 rpm under continuous water cooling.

Composite resin remnants are removed using a fine-grit Arkansas white stone bur (aluminum oxide) operated at 10,000-15,000 rpm under continuous air-water spray irrigation until the enamel surface is clear.

실험적: Rubber-Impregnated Polishing Point

Residual composite adhesive remnants on eligible teeth are cleaned using a rubber-impregnated polishing point operated at 10,000-15,000 rpm under continuous water cooling

Residual adhesive tags are removed and polished using a rubber-impregnated composite polishing point operated at 10,000-15,000 rpm under continuous air-water spray irrigation

연구는 무엇을 측정합니까?

주요 결과 측정

결과 측정
측정값 설명
기간
Postoperative Hypersensitivity
기간: Baseline (immediately post-debonding, before clean-up), 24 hours, and 7 days post-adhesive removal.

Patient-reported pain and hypersensitivity evaluated using a Visual Analogue Scale (VAS) score ranging from 0 (No pain) to 10 (Unbearable severe pain) in response to a 2-second dental syringe air-blast stimulus test.

Baseline (immediately post-debonding, before clean-up), 24 hours, and 7 days post-adhesive removal.

2차 결과 측정

결과 측정
측정값 설명
기간
Procedure Time
기간: Immediately during the clean-up procedure.

Time taken to perform complete residual adhesive removal per tooth, measured using a stopwatch

Immediately during the clean-up procedure.

공동 작업자 및 조사자

여기에서 이 연구와 관련된 사람과 조직을 찾을 수 있습니다.

수사관

  • 연구 책임자: Heba El-Deeb, PhD, Cairo to Department of Conservative Dentistry, Faculty of Dentistry, Cairo University .

연구 기록 날짜

이 날짜는 ClinicalTrials.gov에 대한 연구 기록 및 요약 결과 제출의 진행 상황을 추적합니다. 연구 기록 및 보고된 결과는 공개 웹사이트에 게시되기 전에 특정 품질 관리 기준을 충족하는지 확인하기 위해 국립 의학 도서관(NLM)에서 검토합니다.

연구 주요 날짜

연구 시작 (추정된)

2026년 11월 1일

기본 완료 (추정된)

2027년 6월 1일

연구 완료 (추정된)

2027년 10월 1일

연구 등록 날짜

최초 제출

2026년 11월 9일

QC 기준을 충족하는 최초 제출

2026년 11월 9일

처음 게시됨 (실제)

2026년 11월 13일

연구 기록 업데이트

마지막 업데이트 게시됨 (실제)

2026년 11월 13일

QC 기준을 충족하는 마지막 업데이트 제출

2026년 11월 9일

마지막으로 확인됨

2026년 11월 1일

추가 정보

이 연구와 관련된 용어

추가 관련 MeSH 약관

기타 연구 ID 번호

  • CONS 3-4-1

개별 참가자 데이터(IPD) 계획

개별 참가자 데이터(IPD)를 공유할 계획입니까?

아니요

약물 및 장치 정보, 연구 문서

미국 FDA 규제 의약품 연구

아니

미국 FDA 규제 기기 제품 연구

아니

이 정보는 변경 없이 clinicaltrials.gov 웹사이트에서 직접 가져온 것입니다. 귀하의 연구 세부 정보를 변경, 제거 또는 업데이트하도록 요청하는 경우 register@clinicaltrials.gov. 문의하십시오. 변경 사항이 clinicaltrials.gov에 구현되는 즉시 저희 웹사이트에도 자동으로 업데이트됩니다. .

구독하다