Changes in Trunk Stability Indicators Following Two Types of Exhausting Physical Activities (TNC-FAT)

It has been shown, that fatiguing a muscles in a kinetic chain leads to changes in activities of other non-fatigued muscles during postural tasks. This indicates that central changes take place to adapt the muscle responses according to the new state of the kinetic chain. However, these studies have mainly been focused on studying the effects of localized isometrically induced muscular fatigue that is less relevant to the sport community. In sports training, trunk muscle fatigue is often induced by performing dynamic strength training during a workout session, followed by other training interventions that pose high demands on trunk stability. On the other hand, more complex and gross motor tasks are used such as running, that also have the potential to influence trunk stability. Their effect on trunk stability comes from changes in muscle function as well as form increased ventilation. In both cases, trunk stability can be affected, leading to increased risk of injury. Especially the localized fatigue of the trunk muscles can have a direct effect on trunk stabilizing activities. One might speculate, that the intramuscular coordination can change as to compensate for the decreased ability of the trunk muscles to produce trunk and spinal stabilization impulses. After exhaustive running, especially trunk extensors might be affected, because of the increased trunk forward lean. In addition, trunk muscles are important contributors to increased ventilation in such tasks. As opposed to isolated fatiguing, running might have more complex effects on the trunk stabilization.

It is of most relevance for sports trainers and health care community dealing with athletes to be familiar with the effects of exhaustive running and localized trunk muscle fatigue on trunk and spinal stability in order to be better suited in preventing low back pain. This understanding will enable preparation of more suited training plans, periodization and individualization approaches.

This study will recruit volunteers form local university. Each participant will receive his own identification code that will be known only to the principal investigator. In order to account for the possible bias of the investigators, these will not be allowed to participate in assessing subject, which they are familiar with. Six investigators will participate, all trained in performing the measurement and fatiguing protocols.

All participants will be familiarized with the measurement tasks to overcome possible misunderstandings during the study and to ensure most fluent execution of the measurement protocol. The familiarization will account for as much time as needed for the participants to become proficient in each assessment task. Each participant will sigh an informed consent form that will be prepared in accordance with declaration of Helsinki.

Prior to starting the measurements, each subject will perform a worm-up. The measurement will follow in a predefined order, starting with the EMG electrode placement. First subjects will (ii) perform measurements of trunk muscles reflex responses during a sudden hand loading, followed by (iii) measurements of anticipatory postural adjustments during a quick arm rising test, (iv) body sway during a sitting balance tasks, (v) joint position test and (vi) measurements of maximal voluntary contraction for trunk extension and flexion in a neutral upright stance. Next, subjects will perform a fatiguing protocol. One group of subjects will perform a twelve-minute running test (Coopers test) with the goal to cower as much distance as possible. Subjects in the second group will perform dynamic strengthening exercises (curl-up, right lateral trunk flexion, trunk extension and left lateral trunk flexion), each session performed until exhaustion. All together subjects in a dynamic strengthening group will perform three sets with minimal rest in between. Immediately after finishing the fatiguing protocol, the above measurement protocol will be repeated in the same order.

The measurement data will be saved to a personal computers encoded with the subject's identification code. During data acquisition, processing, statistical analysis and data presentation only identification codes will be used. No individual data will be presented. All data will be gathered in a common data sheet for further statistical analysis.

Prior to performing the study, the sample size will be calculated based on the effect size of data gathered during a pilot study using 10 subjects. For main results, fallowing statistics will be calculated:

• Descriptive statistics.
• For parameters not normally distributed, appropriate corrections will be made.
• Intra-group differences prior to fatiguing protocol will be identified using the T-test for independent samples.
• For parameters, where no baseline differences between the two groups were observed, a Two-way repeated measures ANOVA model will be used to observe the possible changes after fatiguing protocols and possible interaction effects for the two groups. Observed differences will be additionally studied with post-hock tests.
• In cases where the baseline status between the two groups will be different, ANCOVA model will be used.
• Correlations between the parameters will be studied using Pearson correlation coefficient.