Tämä sivu käännettiin automaattisesti, eikä käännösten tarkkuutta voida taata. Katso englanninkielinen versio lähdetekstiä varten.

Comparison of Maxillary Canine Retraction Rate With and Without Power Arm

tiistai 22. syyskuuta 2026 päivittänyt: Tanzila Rafique

Comparison of Maxillary Canine Retraction Rate With and Without Power Arm: A Split-Mouth Randomized Control Trial

The goal of this split-mouth randomized clinical trial is to compare maxillary canine retraction with and without power arm during fixed orthodontic treatment.The main question it aims to answer is What are the differences in the rate of maxillary canine retraction between the power- arm technique and the direct sliding technique over a 6-month period time?

Tutkimuksen yleiskatsaus

Yksityiskohtainen kuvaus

Researchers will compare a power arm placed in the vertical slot of the canine bracket with elastomeric chain to a mini-screw (experimental/PAS) against a conventional elastomeric chain from the canine bracket directly to a mini-screw (control/DS) during canine retraction phase.

Participants will:

  • undergo bilateral maxillary first premolar extractions, followed by placement of a titanium mini-screw or TAD (Vector TAS, 1.4×8.0 mm) between second premolar and first molar on each side for anchorage.
  • receive fixed orthodontic treatment using a pre-adjusted edgewise appliance system (Roth, 0.018-inch slot).
  • have levelling and alignment carried out using a graduated arch-wire sequence (0.014-inch, 0.016-inch, 0.016×0.016-inch, 0.016×0.022-inch, and 0.017×0.025-inch), with angulation corrections addressed at this stage.
  • have bilateral canine retraction initiated three months post-extraction on a 0.016×0.022-inch stainless steel arch-wire, with an elastomeric chain attaching from the power arm to the mini-screw on the experimental (PAS) side and directly from the canine bracket to the mini-screw on the control (DS) side, under a standardized force of 150g reactivated every 21 days.
  • be evaluated via CBCT at baseline (T0) and at 3 and 6 months (T1, T2) to measure canine retraction rate and angulation change on both sides

Opintotyyppi

Interventio

Ilmoittautuminen (Arvioitu)

28

Vaihe

  • Ei sovellettavissa

Yhteystiedot ja paikat

Tässä osiossa on tutkimuksen suorittajien yhteystiedot ja tiedot siitä, missä tämä tutkimus suoritetaan.

Opiskelupaikat

      • Dhaka, Bangladesh, 1215
        • Bangladesh Medical University (BMU), Dhaka,1000

Osallistumiskriteerit

Tutkijat etsivät ihmisiä, jotka sopivat tiettyyn kuvaukseen, jota kutsutaan kelpoisuuskriteereiksi. Joitakin esimerkkejä näistä kriteereistä ovat henkilön yleinen terveydentila tai aiemmat hoidot.

Kelpoisuusvaatimukset

Opintokelpoiset iät

18 vuotta - 25 vuotta (Aikuinen)

Hyväksyy terveitä vapaaehtoisia

Joo

Sukupuolet, jotka voivat opiskella

Kaikki

Kuvaus

Inclusion Criteria:

  • Participant with Angle's class I and class II malocclusion who required both maxillary bilateral premolar extraction for orthodontic treatment.
  • Participants who required maximum anchorage.
  • Participants with good general health condition and oral hygiene status.
  • Age range of the participants will be 18 to 25 years.
  • Sex of the participants will be both male and female.
  • Participants with full permanent dentition present (excluding 3 rd molar).
  • Participants who have completed the levelling and alignment phase before the start of canine retraction.
  • Participants with no caries, fracture, periapical lesion, root resorption, morphological variation or other pathology involving the maxillary canine.

Exclusion Criteria:

  • Participants with systemic conditions affecting bone metabolism or orthodontic tooth movement (e.g., diabetes mellitus, osteoporosis).
  • Participants with impacted or displaced maxillary canines.
  • Participants with retained deciduous canines.
  • Participants with dental anomalies affecting canine retraction.
  • Participants with previous orthodontic treatment.
  • Participants with cleft lip/palate, craniofacial syndromes, or facial asymmetry.
  • Participants requiring surgical orthodontic treatment.
  • Pregnant women.
  • Participants with poor cooperation, missed appointments, or frequent appliance breakage.
  • Habit of smoking.

Opintosuunnitelma

Tässä osiossa on tietoja tutkimussuunnitelmasta, mukaan lukien kuinka tutkimus on suunniteltu ja mitä tutkimuksella mitataan.

Miten tutkimus on suunniteltu?

Suunnittelun yksityiskohdat

  • Ensisijainen käyttötarkoitus: Hoito
  • Jako: Satunnaistettu
  • Inventiomalli: Rinnakkaistehtävä
  • Naamiointi: Ei mitään (avoin tarra)

Aseet ja interventiot

Osallistujaryhmä / Arm
Interventio / Hoito
Kokeellinen: Power Arm sliding technique

Experimental: Power Arm sliding techniqueA power arm placed in the vertical slot of the canine bracket and elastomeric chain attached from power arm to mini-screw.

Experimental: Power Arm sliding technique: A power arm placed in the vertical slot of the canine bracket and elastomeric chain attached from power arm to mini-screw.

Active Comparator / Control: direct sliding technique:

Elastomeric chain applied directly from the canine bracket to a mini-screw on the contralateral side.

Muut nimet:
  • Experimental: Power Arm sliding technique
  • Active Comparator / Control: direct sliding technique
Active Comparator: Control: direct sliding technique

Active Comparator / Control: direct sliding technique: Elastomeric chain applied directly from the canine bracket to a mini-screw on the contralateral side.

Experimental: Power Arm sliding technique: A power arm placed in the vertical slot of the canine bracket and elastomeric chain attached from power arm to mini-screw.

Active Comparator / Control: direct sliding technique:

Elastomeric chain applied directly from the canine bracket to a mini-screw on the contralateral side.

Muut nimet:
  • Experimental: Power Arm sliding technique
  • Active Comparator / Control: direct sliding technique

Mitä tutkimuksessa mitataan?

Ensisijaiset tulostoimenpiteet

Tulosmittaus
Toimenpiteen kuvaus
Aikaikkuna
Primary outcome measure
Aikaikkuna: 6 months

This split-mouth randomized clinical trial will compare maxillary canine retraction (in mm) with and without a power arm during fixed orthodontic treatment.

6 months

Toissijaiset tulostoimenpiteet

Tulosmittaus
Toimenpiteen kuvaus
Aikaikkuna
Secondary outcome measures
Aikaikkuna: 6 months
  • Participants will receive fixed orthodontic treatment using a pre-adjusted edgewise appliance system (Roth, 0.018-inch slot).
  • Bilateral maxillary first premolar extractions will be done followed by placement of a titanium mini-screw or TAD (Vector TAS, 1.4×8.0 mm) between the second premolar and first molar on each side.
  • Levelling and alignment will be carriedout using a graduated arch-wire sequence (0.014-inch, 0.016-inch, 0.016×0.016-inch, 0.016×0.022-inch, and 0.017×0.025-inch).
  • Bilateral canine retraction will be initiated three months post-extraction on a 0.016×0.022-inch stainless steel arch-wire, with an elastomeric chain attaching from the power arm to the mini-screw on the experimental (PAS) side and directly from the canine bracket to the mini-screw on the control (DS) side, under a force of 150g reactivated every 21 days.
  • Evaluation will be done at 3 and 6 months to measure canine retraction rate (in mm) and angulation changes(in degrees) at both side.
6 months

Yhteistyökumppanit ja tutkijat

Täältä löydät tähän tutkimukseen osallistuvat ihmiset ja organisaatiot.

Sponsori

Tutkijat

  • Opintojohtaja: Mahmood Sajedeen, BDS,FCPS, Bangladesh Medical University (BMU)
  • Opintojohtaja: Sajedeen, Bangladesh Medical University (BMU), Dhaka-1000

Opintojen ennätyspäivät

Nämä päivämäärät seuraavat ClinicalTrials.gov-sivustolle lähetettyjen tutkimustietueiden ja yhteenvetojen edistymistä. National Library of Medicine (NLM) tarkistaa tutkimustiedot ja raportoidut tulokset varmistaakseen, että ne täyttävät tietyt laadunvalvontastandardit, ennen kuin ne julkaistaan ​​julkisella verkkosivustolla.

Opi tärkeimmät päivämäärät

Opiskelun aloitus (Todellinen)

Tiistai 18. elokuuta 2026

Ensisijainen valmistuminen (Arvioitu)

Tiistai 17. elokuuta 2027

Opintojen valmistuminen (Arvioitu)

Tiistai 17. elokuuta 2027

Opintoihin ilmoittautumispäivät

Ensimmäinen lähetetty

Torstai 3. syyskuuta 2026

Ensimmäinen toimitettu, joka täytti QC-kriteerit

Torstai 17. syyskuuta 2026

Ensimmäinen Lähetetty (Todellinen)

Keskiviikko 23. syyskuuta 2026

Tutkimustietojen päivitykset

Viimeisin päivitys julkaistu (Todellinen)

Torstai 24. syyskuuta 2026

Viimeisin lähetetty päivitys, joka täytti QC-kriteerit

Tiistai 22. syyskuuta 2026

Viimeksi vahvistettu

Tiistai 1. syyskuuta 2026

Lisää tietoa

Tähän tutkimukseen liittyvät termit

Muut tutkimustunnusnumerot

  • BMU/2026/8639

Yksittäisten osallistujien tietojen suunnitelma (IPD)

Aiotko jakaa yksittäisten osallistujien tietoja (IPD)?

EI

Lääke- ja laitetiedot, tutkimusasiakirjat

Tutkii yhdysvaltalaista FDA sääntelemää lääkevalmistetta

Ei

Tutkii yhdysvaltalaista FDA sääntelemää laitetuotetta

Ei

Nämä tiedot haettiin suoraan verkkosivustolta clinicaltrials.gov ilman muutoksia. Jos sinulla on pyyntöjä muuttaa, poistaa tai päivittää tutkimustietojasi, ota yhteyttä register@clinicaltrials.gov. Heti kun muutos on otettu käyttöön osoitteessa clinicaltrials.gov, se päivitetään automaattisesti myös verkkosivustollemme .

Tilaa