Denna sida har översatts automatiskt och översättningens korrekthet kan inte garanteras. Vänligen se engelsk version för en källtext.

Guided Biofilm Therapy Versus Conventional Polishing for Tooth Re-Staining

28 augusti 2026 uppdaterad av: Mehmet Ali Tuna, Ataturk University

Guided Biofilm Therapy Versus Conventional Polishing for Extrinsic Tooth Re-Staining, Patient Comfort, and Procedure Time: A Randomized Split-Mouth Trial

This study compared Guided Biofilm Therapy with conventional polishing in adults with visible extrinsic tooth staining. Each participant received Guided Biofilm Therapy on one side of the mouth and conventional polishing on the other side.

The study evaluated whether the two methods differed in the amount of tooth re-staining after treatment, patient discomfort during the procedures, and total procedure time. Tooth color was measured with a spectrophotometer immediately after treatment, at 1 month, and at 2 months. Patient discomfort was recorded using a visual analog scale, and procedure time was measured with a stopwatch.

A total of 34 participants completed the study.

Studieöversikt

Status

Avslutad

Betingelser

Intervention / Behandling

Detaljerad beskrivning

This randomized split-mouth clinical trial was conducted in adults with visible extrinsic tooth staining. The aim was to compare Guided Biofilm Therapy (GBT) with conventional polishing in terms of post-procedural extrinsic tooth re-staining, patient discomfort, and procedure time.

Each participant received both interventions. One side of the mouth was assigned to GBT and the contralateral side to conventional polishing. The right-left allocation of the interventions was determined by randomization, with the two allocation sequences equally distributed among participants.

In the GBT intervention, dental biofilm was first disclosed and then removed using an air-water-powder system with a low-abrasive erythritol-based powder. Supragingival ultrasonic instrumentation was performed where necessary. In the conventional polishing intervention, supragingival instrumentation was followed by mechanical polishing with a brush and polishing paste.

Tooth color was assessed using a SpectroShade Micro spectrophotometer and the CIELAB color system. Measurements were performed immediately after treatment at baseline (T0), at 1 month (T1), and at 2 months (T2). Color change between assessment periods was calculated using ΔE*ab values.

Patient-reported discomfort was assessed immediately after each half-mouth procedure using a visual analog scale. Total procedure time for each intervention was recorded with a stopwatch.

The primary outcome was color change from immediately after treatment to 2 months. Secondary outcomes included color change from immediately after treatment to 1 month, color change from 1 month to 2 months, patient discomfort, and procedure time.

A total of 34 participants completed all study visits and follow-up assessments.

Studietyp

Interventionell

Inskrivning (Faktisk)

34

Fas

  • Inte tillämpbar

Kontakter och platser

Det här avsnittet innehåller kontaktuppgifter för dem som genomför studien och information om var denna studie genomförs.

Studieorter

  • Turkiet (Türkiye)
    • Erzurum
      • Erzurum, Erzurum, Turkiet (Türkiye), 25080
        • Ataturk University

Deltagandekriterier

Forskare letar efter personer som passar en viss beskrivning, så kallade behörighetskriterier. Några exempel på dessa kriterier är en persons allmänna hälsotillstånd eller tidigare behandlingar.

Urvalskriterier

Åldrar som är berättigade till studier

  • Vuxen
  • Äldre vuxen

Tar emot friska volontärer

Ja

Beskrivning

Inclusion Criteria:

  • Age over 18 years.
  • Willingness to participate in the study and provision of written informed consent.
  • Good general health with no systemic disease.
  • Clinical presence of extrinsic staining on tooth surfaces at a level warranting professional polishing.
  • Right-handed tooth brushing.
  • No professional dental cleaning within the previous 6 months.

Exclusion Criteria:

  • Age under 18 years.
  • Diagnosis of periodontitis.
  • Current smoking.
  • Antibiotic use within the previous 3 months.
  • Presence of acute periodontal disease.
  • Allergy to polishing powders, specifically erythritol.
  • Presence of a communicable disease.
  • Teeth to be measured with restorations, caries, excessive wear, or structural defects that could affect measurement.
  • Active orthodontic treatment.
  • Developmental or structural anomalies affecting enamel and potentially increasing susceptibility to extrinsic staining, including hypomineralization, amelogenesis imperfecta, or dentinogenesis imperfecta.
  • Severe dental crowding preventing standardized measurements.

Studieplan

Det här avsnittet ger detaljer om studieplanen, inklusive hur studien är utformad och vad studien mäter.

Hur är studien utformad?

Designdetaljer

  • Primärt syfte: Förebyggande
  • Tilldelning: Randomiserad
  • Interventionsmodell: Crossover tilldelning
  • Maskning: Enda

Vapen och interventioner

Deltagargrupp / Arm
Intervention / Behandling
Experimentell: Sequence A: Right GBT / Left Conventional Polishing
Participants assigned to Sequence A received Guided Biofilm Therapy on the right half of the mouth and conventional polishing on the left half of the mouth. Both interventions were performed within the split-mouth study design.
Procedur: Guided Biofilm Therapy
Dental biofilm was first disclosed to guide treatment. Supragingival biofilm and extrinsic staining were then removed using an air-water-powder system with a low-abrasive erythritol-based powder. Supragingival ultrasonic instrumentation was performed where necessary, followed by final surface control.
Andra namn:
  • GBT
Procedur: Conventional Polishing
Supragingival instrumentation was performed as needed, followed by mechanical polishing with a prophylaxis brush and polishing paste at 2500 to 3000 rpm. The procedure was completed with final surface control.
Andra namn:
  • CONV
Experimentell: Sequence B: Right Conventional Polishing / Left GBT
Participants assigned to Sequence B received conventional polishing on the right half of the mouth and Guided Biofilm Therapy on the left half of the mouth. Both interventions were performed within the split-mouth study design.
Procedur: Guided Biofilm Therapy
Dental biofilm was first disclosed to guide treatment. Supragingival biofilm and extrinsic staining were then removed using an air-water-powder system with a low-abrasive erythritol-based powder. Supragingival ultrasonic instrumentation was performed where necessary, followed by final surface control.
Andra namn:
  • GBT
Procedur: Conventional Polishing
Supragingival instrumentation was performed as needed, followed by mechanical polishing with a prophylaxis brush and polishing paste at 2500 to 3000 rpm. The procedure was completed with final surface control.
Andra namn:
  • CONV

Vad mäter studien?

Primära resultatmått

Resultatmått
Åtgärdsbeskrivning
Tidsram
Change in Tooth Color From Immediately After Treatment to 2 Months Assessed by CIELAB ΔE*ab Using a SpectroShade Micro Spectrophotometer
Tidsram: Immediately after treatment (Day 1) and at 2 months
Tooth color was measured using a SpectroShade Micro spectrophotometer according to the CIELAB color system. Color change between immediately after treatment (T0) and 2 months (T2) was calculated as ΔEab using the formula: ΔEab = [(ΔL*)² + (Δa*)² + (Δb*)²]^(1/2). ΔEab is a continuous color-difference measure, with 0 indicating no color difference and higher values indicating greater color change. Therefore, lower ΔEab values indicate greater color stability.
Immediately after treatment (Day 1) and at 2 months

Sekundära resultatmått

Resultatmått
Åtgärdsbeskrivning
Tidsram
Change in Tooth Color From Immediately After Treatment to 1 Month Assessed by CIELAB ΔE*ab Using a SpectroShade Micro Spectrophotometer
Tidsram: Immediately after treatment (Day 1) and at 1 month
Tooth color was measured using a SpectroShade Micro spectrophotometer according to the CIELAB color system. Color change between immediately after treatment (T0) and 1 month (T1) was calculated as ΔEab using the formula: ΔEab = [(ΔL*)² + (Δa*)² + (Δb*)²]^(1/2). ΔEab is a continuous color-difference measure, with 0 indicating no color difference and higher values indicating greater color change. Therefore, lower ΔEab values indicate greater color stability.
Immediately after treatment (Day 1) and at 1 month
Change in Tooth Color From 1 Month to 2 Months
Tidsram: At 1 month and 2 months
Tooth color was measured using a SpectroShade Micro spectrophotometer according to the CIELAB color system. Color change between 1 month (M1) and 2 months (M2) was calculated as ΔE*ab using the formula: ΔE*ab = [(ΔL*)² + (Δa*)² + (Δb*)²]^(1/2). Lower ΔE*ab values indicate less color change.
At 1 month and 2 months
Patient-Reported Discomfort Assessed Using a 10-cm Visual Analog Scale
Tidsram: Immediately after completion of each half-mouth intervention (Day 1)
Patient-reported discomfort was assessed immediately after each half-mouth procedure using a 10-cm visual analog scale ranging from 0 to 10, where 0 indicated no discomfort and 10 indicated unbearable discomfort. The score reflected the overall perception of pain or sensitivity, heat, pressure or vibration, and discomfort related to water spray or aerosol. Lower scores indicate greater patient comfort.
Immediately after completion of each half-mouth intervention (Day 1)
Total Procedure Time Measured Using a Digital Stopwatch
Tidsram: Periprocedural
Total procedure time for each intervention was recorded using a digital stopwatch. Timing began with the first clinical step of the relevant intervention and ended after completion of the final surface check. Patient preparation, isolation, and oral hygiene instruction were excluded. Procedure time was recorded in minutes and seconds, with shorter times indicating greater procedural efficiency.
Periprocedural

Samarbetspartners och utredare

Det är här du hittar personer och organisationer som är involverade i denna studie.

Sponsor

Ataturk University

Utredare

  • Studierektor: Recep Orbak, DDS, PhD, Ataturk University

Studieavstämningsdatum

Dessa datum spårar framstegen för inlämningar av studieposter och sammanfattande resultat till ClinicalTrials.gov. Studieposter och rapporterade resultat granskas av National Library of Medicine (NLM) för att säkerställa att de uppfyller specifika kvalitetskontrollstandarder innan de publiceras på den offentliga webbplatsen.

Studera stora datum

Studiestart (Faktisk)

5 januari 2026

Primärt slutförande (Faktisk)

1 juni 2026

Avslutad studie (Faktisk)

8 juni 2026

Studieregistreringsdatum

Först inskickad

18 augusti 2026

Först inskickad som uppfyllde QC-kriterierna

28 augusti 2026

Första postat (Faktisk)

2 september 2026

Uppdateringar av studier

Senaste uppdatering publicerad (Faktisk)

2 september 2026

Senaste inskickade uppdateringen som uppfyllde QC-kriterierna

28 augusti 2026

Senast verifierad

1 augusti 2026

Mer information

Termer relaterade till denna studie

Nyckelord

Ytterligare relevanta MeSH-villkor

Andra studie-ID-nummer

  • 926

Plan för individuella deltagardata (IPD)

Planerar du att dela individuella deltagardata (IPD)?

JA

IPD-planbeskrivning

De-identified individual participant data underlying the results reported in the published article will be shared. These data may include participant-level demographic variables, treatment allocation, ΔE*ab color-change outcomes, visual analog scale scores, and procedure-time data necessary to reproduce the reported analyses.

Tidsram för IPD-delning

Data and supporting information will be available beginning 6 months after publication of the study results and will remain available for 5 years.

Kriterier för IPD Sharing Access

Qualified researchers may request access from the corresponding author for scientifically justified research purposes. Requests should include a brief research proposal describing the purpose of the analysis and the data requested. Access will be considered following review of the proposed use and applicable ethical and confidentiality requirements. Only de-identified data relevant to the approved request will be shared electronically.

IPD-delning som stöder informationstyp

  • STUDY_PROTOCOL

Läkemedels- och apparatinformation, studiedokument

Studerar en amerikansk FDA-reglerad läkemedelsprodukt

Nej

Studerar en amerikansk FDA-reglerad produktprodukt

Nej

produkt tillverkad i och exporterad från U.S.A.

Nej

Denna information hämtades direkt från webbplatsen clinicaltrials.gov utan några ändringar. Om du har några önskemål om att ändra, ta bort eller uppdatera dina studieuppgifter, vänligen kontakta register@clinicaltrials.gov. Så snart en ändring har implementerats på clinicaltrials.gov, kommer denna att uppdateras automatiskt även på vår webbplats .

Prenumerera