- ICH GCP
- Amerikanska kliniska prövningsregistret
- Klinisk prövning NCT07700095
Three-Dimensional Bone Augmentation of Severely Atrophied Posterior Mandibular Alveolar Ridges Using Customized-3D Zirconia Barriers Versus Pre-bent Titanium Mesh
Assessment of Three-Dimensional Bone Augmentation of Severely Atrophied Posterior Mandibular Alveolar Ridges Using Customized-3D Zirconia Barriers Versus Pre-bent Titanium Mesh: A Randomized Controlled Clinical Trial
Zirconia can be considered as an alternative and innovative material suitable for GBR because it has high biocompatibility, together with a scarce tissue integration. Zirconia barriers could be a predictable and alternative barrier material for GBR in terms of (i) biocompatibility, (ii) ease of use and removal, (iii) exposure management, (iv) bone regeneration outcomes.
Studieöversikt
Status
Betingelser
Intervention / Behandling
Studietyp
Inskrivning (Faktisk)
Fas
- Inte tillämpbar
Kontakter och platser
Studieorter
-
-
-
Kafr Elsheikh, Egypten
- Kafr El-sheikh University
-
-
Deltagandekriterier
Urvalskriterier
Åldrar som är berättigade till studier
Tar emot friska volontärer
Kön som är behöriga för studier
Beskrivning
Inclusion Criteria:
- Patients are systemically medically free according to the American Society of Anesthesiologists (ASA) considered as ASA I.
- Ability to maintain good oral hygiene as evidenced in recall visits.
- patients who had a partial or completely edentulous alveolar ridge with apparent 3D defect following teeth loss.
- All patients were free from any local or general disease that may interfere with bone healing and had no history of previous grafting procedure at the designated edentulous ridge.
- The ridge had to exhibit severe vertical and horizontal (3D) alveolar ridge deficiency with alveolar ridge height less than 7 mm from the alveolar crest to the inferior alveolar canal and width less than 5 mm which was firstly measured by CBCT, or a clinically apparent increase in inter-arch space relative to the adjacent natural teeth.
- Pre-operative clinical assessment of soft tissue coverage was done to cover the graft and its membrane, in addition to assessment of occlusion and inter-arch distance should allow for the graft, membrane, implan and the future prosthesis.
Exclusion Criteria:
- Smoker (> 25 cigarettes/ day).
- Patients undergoing radiotherapy or chemotherapy
- Patients having infection or local lesions in the area of surgery.
- Patients with diabetes mellitus or bone diseases which may compromise the results.
- Patient with poor oral hygiene or active periodontal disease.
- Patient with limited mouth opening.
- Participation in other clinical trials
Studieplan
Hur är studien utformad?
Designdetaljer
- Primärt syfte: Behandling
- Tilldelning: Randomiserad
- Interventionsmodell: Parallellt uppdrag
- Maskning: Ingen (Open Label)
Vapen och interventioner
Deltagargrupp / Arm |
Intervention / Behandling |
|---|---|
|
Experimentell: Zirkoniumoxid
|
It includes eight patients seeking for placement of customized Zirconia barrier after GBR in 1st stage surgery then implants placement in 2nd stage surgery in the alveolar ridges. |
|
Experimentell: Titanium
|
It includes eight patients seeking for placement prebent titanium mesh as barriers after GBR in 1st stage surgery then implants placement in 2nd stage surgery in the alveolar ridges. |
Vad mäter studien?
Primära resultatmått
Resultatmått |
Åtgärdsbeskrivning |
Tidsram |
|---|---|---|
|
change in vertical height of ridge
Tidsram: up to 6 months
|
Cone Beam Computed Tomography (CBCT) was done immediately (1 week) and after six months to evaluate the changes in vertical, horizontal and volumetric measurements of the ridge. OnDemand3D™ software was used to evaluate vertical and horizontal height. Measurements were taken as follows: From the toolbar, the ruler was selected from the measurement section. |
up to 6 months
|
|
change in horizontal width of ridge
Tidsram: up to 6 months
|
Cone Beam Computed Tomography (CBCT) will be done immediately (1 week) and after six months OnDemand3D™ software will be used. Measurements were taken as follows: From the toolbar, the ruler was selected from the measurement section. |
up to 6 months
|
|
change in volume of ridge
Tidsram: up to 6 months
|
Cone Beam Computed Tomography (CBCT) will be done immediately (1 week) and after six months OnDemand3D™ software will be used. Measurements were taken as follows: From the toolbar, the ruler was selected from the measurement section. |
up to 6 months
|
Sekundära resultatmått
Resultatmått |
Åtgärdsbeskrivning |
Tidsram |
|---|---|---|
|
symptoms of infection
Tidsram: up to one month
|
Any symptoms of infection including swelling, redness, hotness, pus discharge, and pain will be recorded |
up to one month
|
|
manifestations of wound healing disturbance
Tidsram: up to one month
|
observation for any manifestations of wound healing disturbance, as wound dehiscence and hardware exposure will be recorded |
up to one month
|
Samarbetspartners och utredare
Sponsor
Studieavstämningsdatum
Studera stora datum
Studiestart (Faktisk)
Primärt slutförande (Faktisk)
Avslutad studie (Faktisk)
Studieregistreringsdatum
Först inskickad
Först inskickad som uppfyllde QC-kriterierna
Första postat (Faktisk)
Uppdateringar av studier
Senaste uppdatering publicerad (Faktisk)
Senaste inskickade uppdateringen som uppfyllde QC-kriterierna
Senast verifierad
Mer information
Termer relaterade till denna studie
Andra studie-ID-nummer
- KFSIRB200-205
Läkemedels- och apparatinformation, studiedokument
Studerar en amerikansk FDA-reglerad läkemedelsprodukt
Studerar en amerikansk FDA-reglerad produktprodukt
Denna information hämtades direkt från webbplatsen clinicaltrials.gov utan några ändringar. Om du har några önskemål om att ändra, ta bort eller uppdatera dina studieuppgifter, vänligen kontakta register@clinicaltrials.gov. Så snart en ändring har implementerats på clinicaltrials.gov, kommer denna att uppdateras automatiskt även på vår webbplats .