Questa pagina è stata tradotta automaticamente e l'accuratezza della traduzione non è garantita. Si prega di fare riferimento al Versione inglese per un testo di partenza.

Effect of Different Resin Composite Packing Techniques on Pulp Condition (Randomized Clinical Trial)

4 luglio 2026 aggiornato da: Esraa Mohamed Zaki, October 6 University

The goal of this clinical trial is to evalute the effect of different resin composite packing techniques on pulpal condition in patient with deep carious occlusal cavities in their molar teeth. The main questions it aims to answer are:

  • Do composite packing technquies cause pulpal inflammatory response ?
  • Do composite packing technquies cause post operative pain ? Researchers will compare elastic cavity liner packing techniques to sonic activated and flowable bulk packing techniques to see their effect on pulp condition.

Participants will :

  • Provide an honest medial and dental history to undergo the restorative procedures .
  • Report subjective symptons.
  • Attend all scheduled follow-ups visit for pulp assessment.

Panoramica dello studio

Stato

Completato

Condizioni

Intervento / Trattamento

Descrizione dettagliata

This clinical study evaluates the impact of various resin composite packing techniques on pulp inflammation and post-operative condition, specifically comparing the biological and mechanical outcomes of incremental layering of packable composite with flowable liner versus modern bulk-fill strategies as SoniFill bulk fill resin composite and SDR bulk fill composite. The research involves preparing standardized cavities in clinical participants and restoring them using specialized resin materials to determine how different application methods influence polymerization shrinkage stress, marginal adaptation, and dentinal tubule fluid movement. To quantify the subclinical inflammatory response of the pulp, Gingival Crevicular Fluid (GCF) samples are collected from the gingival sulcus of the restored teeth at baseline and specific post-operative intervals (immediately and after one week ) to analyze changes in inflammatory mediators or biomarkers. Simultaneously, the patient's subjective experience of post-operative pain and thermal sensitivity is recorded using the Visual Analog Scale (VAS), where participants mark their level of discomfort on a 10-cm line to provide measurable data on clinical symptoms. By correlating these objective biochemical markers from the GCF with the subjective VAS scores and clinical sensibility testing, the study aims to identify the most effective packing protocol for minimizing C-factor-related stress and protecting the dentin-pulp complex from inflammatory responses.

Tipo di studio

Interventistico

Iscrizione (Effettivo)

30

Fase

  • Fase 4

Contatti e Sedi

Questa sezione fornisce i recapiti di coloro che conducono lo studio e informazioni su dove viene condotto lo studio.

Luoghi di studio

  • Egitto
      • Giza, Egitto, 3235142
        • Ain Shams University

Criteri di partecipazione

I ricercatori cercano persone che corrispondano a una certa descrizione, chiamata criteri di ammissibilità. Alcuni esempi di questi criteri sono le condizioni generali di salute di una persona o trattamenti precedenti.

Criteri di ammissibilità

Età idonea allo studio

  • Adulto

Accetta volontari sani

No

Descrizione

Inclusion Criteria:

  • Both genders.
  • Systemically healthy patients.
  • Good oral hygiene.
  • Available for follow-up appointments.
  • Asymptomatic permanent molars with deep occlusal caries ICDAS 5 or 6 carious lesions and healthy periodontium, in normal occlusion with no previous restorations related to the teeth and vital with a positive response to cold testing.

Exclusion Criteria:

  • Vulnerable populations.
  • Tobacco users.
  • Medically compromised patients, such as those with diabetes or medications affecting salivary flow were excluded.
  • Teeth with prior endodontic treatment, periodontal pockets over 3 mm, or any dental/periodontal therapy within the past 12 months.

Piano di studio

Questa sezione fornisce i dettagli del piano di studio, compreso il modo in cui lo studio è progettato e ciò che lo studio sta misurando.

Come è strutturato lo studio?

Dettagli di progettazione

  • Scopo principale: Trattamento
  • Assegnazione: Randomizzato
  • Modello interventistico: Assegnazione parallela
  • Mascheramento: Doppio

Armi e interventi

Gruppo di partecipanti / Arm
Intervento / Trattamento
Nessun intervento: Flowable liner and packable composite
Following proper administration of local anesthesia , cavity preparation is completed according to the study's standardized dimensions. Isolation is achieved using a rubber dam to ensure a moisture-free operating field. Selective-etch is performed using 37% phosphoric acid, followed by thorough rinsing and gentle air-drying to leave the dentin moist. The bonding agent is applied according to the manufacturer's instructions, gently air-thinned to form a uniform layer, and light-cured for the specified duration. A low-viscosity flowable composite liner is applied to the pulpal floor generally not exceeding 1-2 mm in thickness. he remaining cavity depth is restored using a packable resin composite using an incremental layering technique to minimize polymerization shrinkage stress. Each increment is meticulously adapted to the cavity walls using a hand plugger, anatomically contoured, and light-cured individually from the occlusal surface.
Sperimentale: Sonic Fill bulk fill resin composite

The SonicFill bulk-fill resin composite is delivered directly into the cavity preparation using its specialized, ultrasonically activated handpiece.

The material is placed in a single bulk increment of up to 5 mm, completely filling the cavity to the occlusal margin. Once the sonic activation stops, the material reverts to a sculptable, non-slumping consistency, allowing immediate anatomical contouring. The entire bulk increment is then light-cured from the occlusal surface according to the manufacturer's recommended exposure time and intensity.
Droga: Sonic Fill bulk fill resin composite
The SonicFill bulk-fill resin composite is delivered directly into the cavity preparation using its specialized, ultrasonically activated handpiece. The material is placed in a single bulk increment of up to 5 mm, completely filling the cavity to the occlusal margin. Once the sonic activation stops, the material reverts to a sculptable, non-slumping consistency, allowing immediate anatomical contouring. The entire bulk increment is then light-cured from the occlusal surface according to the manufacturer's recommended exposure time and intensity
Sperimentale: SDR flowable bulk fill resin composite

SDR bulk-fill flowable composite is dispensed directly into the cavity using the manufacturer's syringe tip, starting from the deepest part of the preparation to avoid air entrapment. Due to its self-leveling properties and low polymerization stress, it is placed in a single bulk increment of up to 4 mm, leaving approximately 1.5-2 mm of occlusal space for the capping layer. The material is then light-cured.

The remaining occlusal volume is restored using a conventional packable resin composite to act as the wear-resistant enamel replacement. Then the capping layer is adapted to the cavosurface margins, anatomically contoured to replicate correct tooth morphology, and light-cured.
Procedura: SDR flowable bulk fill resin composite
SDR bulk-fill flowable composite is dispensed directly into the cavity using the manufacturer's syringe tip, starting from the deepest part of the preparation to avoid air entrapment. Due to its self-leveling properties and low polymerization stress, it is placed in a single bulk increment of up to 4 mm, leaving approximately 1.5-2 mm of occlusal space for the capping layer. The material is then light-cured. The remaining occlusal volume is restored using a conventional packable resin composite to act as the wear-resistant enamel replacement. Then the capping layer is adapted to the cavosurface margins, anatomically contoured to replicate correct tooth morphology, and light-cured.

Cosa sta misurando lo studio?

Misure di risultato primarie

Misura del risultato
Misura Descrizione
Lasso di tempo
Pulpal inflammatory responses.
Lasso di tempo: From enrollment to the end of treatment at one year.
Immuno-histological analysis of the crevicular fluid to evalute pulpal inflammatory response by quantifying the volume of the pro-inflammatory cytokine TNF-α in GCF that reflect pulpal inflmmation in response to different resin composite packing techniques.
From enrollment to the end of treatment at one year.

Misure di risultato secondarie

Misura del risultato
Misura Descrizione
Lasso di tempo
Post-operative pain.
Lasso di tempo: From enrollment to the end of treatment at one year.
This evaluation is conducted using the Visual Analog Scale (VAS), a validated 10-cm horizontal line where "0" represents "no pain" and "10" represents "the worst imaginable pain." Participants are instructed to record their subjective perception of discomfort at specific post-operative intervals (before treatment and one week following restorative procedures ). To ensure a comprehensive assessment, pain is categorized into spontaneous pain and provoked pain (sensitivity to thermal stimuli or masticatory pressure). This subjective data is then correlated with the biochemical findings from the Gingival Crevicular Fluid (GCF) samples.
From enrollment to the end of treatment at one year.

Collaboratori e investigatori

Qui è dove troverai le persone e le organizzazioni coinvolte in questo studio.

Sponsor

October 6 University

Studiare le date dei record

Queste date tengono traccia dell'avanzamento della registrazione dello studio e dell'invio dei risultati di sintesi a ClinicalTrials.gov. I record degli studi e i risultati riportati vengono esaminati dalla National Library of Medicine (NLM) per assicurarsi che soddisfino specifici standard di controllo della qualità prima di essere pubblicati sul sito Web pubblico.

Studia le date principali

Inizio studio (Effettivo)

1 febbraio 2025

Completamento primario (Effettivo)

1 gennaio 2026

Completamento dello studio (Effettivo)

1 gennaio 2026

Date di iscrizione allo studio

Primo inviato

4 luglio 2026

Primo inviato che soddisfa i criteri di controllo qualità

4 luglio 2026

Primo Inserito (Effettivo)

10 luglio 2026

Aggiornamenti dei record di studio

Ultimo aggiornamento pubblicato (Effettivo)

10 luglio 2026

Ultimo aggiornamento inviato che soddisfa i criteri QC

4 luglio 2026

Ultimo verificato

1 luglio 2026

Maggiori informazioni

Termini relativi a questo studio

Parole chiave

Termini MeSH pertinenti aggiuntivi

Altri numeri di identificazione dello studio

  • FDASU-Rec IM012562

Informazioni su farmaci e dispositivi, documenti di studio

Studia un prodotto farmaceutico regolamentato dalla FDA degli Stati Uniti

No

Studia un dispositivo regolamentato dalla FDA degli Stati Uniti

No

Queste informazioni sono state recuperate direttamente dal sito web clinicaltrials.gov senza alcuna modifica. In caso di richieste di modifica, rimozione o aggiornamento dei dettagli dello studio, contattare register@clinicaltrials.gov. Non appena verrà implementata una modifica su clinicaltrials.gov, questa verrà aggiornata automaticamente anche sul nostro sito web .

Sottoscrivi