Vliv terapeutické artrocentézy kloubu na bolest a funkci kvadricepsu u pacientů s osteoartrózou kolena

Pain and Self-Reported Function

Knee pain will be assessed with an 11-point numeric pain rating scale (NPRS) where 0 represents 'no pain' and 10 represents 'worst imaginable pain'. Self-reported physical function will be assessed using the Western Ontario and McMaster Universities Osteoarthritis Index (WOMAC) for each knee separately. The WOMAC assesses the impact of knee osteoarthritis on multiple domains-pain, stiffness, and disability. A composite score (0-100 scale) will be used for analysis.

Range of Motion

Knee range of motion (ROM) is a direct measure of joint mobility following TKA. Knee ROM will be measured in the supine position both actively and passively using a long-arm goniometer. Goniometry has been shown to be a reliable measure of knee ROM after TKA.

Quadriceps Strength and Activation Testing

Maximum voluntary isometric quadriceps strength and quadriceps activation will be assessed before surgery and at week 3 using an electromechanical dynamometer (Humac Norm, CSMI) and a doublet interpolation test. Patients will be seated on the electromechanical dynamometer with their hips flexed to approximately 85° and their knees flexed to 60°. Two 3" by 5" self-adhesive neuromuscular stimulation electrodes will be placed over the motor points of the rectus femoris and the vastus medialis. A Grass S48 stimulator with a Grass Model SIU8T stimulus isolation unit will be used to deliver 600 µs doublet pulses. A Biopac MP150WSW system will be used for data acquisition during testing with sampling frequency of 300 Hz.

Following two warm-up contractions, a practice maximal voluntary isometric contraction (MVIC) will be performed against the dynamometer's force transducer. Visual torque targets will be set on the feedback monitor at slightly higher torques than produced during the practice MVIC trial. Trials will be repeated until maximal torque is within 5% of the previous attempt. Torque from quadriceps MVIC will be normalized to body weight for between-subject comparisons.

Voluntary activation of the quadriceps muscle will be assessed using the doublet interpolation technique, where a supramaximal stimulus will be applied by a Grass S48 stimulator during an MVIC and immediately afterwards while the quadriceps muscle is at

rest. Normalization of the force from the superimposed doublet to the resting doublet allows for comparisons of quadriceps activation across individuals and lower extremities.

Timed-Up-and-Go

The timed-up-and-go (TUG) test is a responsive, valid, and reliable functional measure of basic mobility and dynamic balance. The examiner measures the time, in seconds, required by the patient to a) rise from an arm chair; b) walk 3 meters; c) turn and walk back to the arm chair; and d) return to the seated position.

30-second Sit-to-Stand Test

The 30-second Sit-to-Stand test (30STS) is a responsive, valid, and reliable functional measure of lower extremity strength after TKA. This test counts the number of times a patient can rise to a full standing position in 30 seconds. The test starting position is sitting on an armless chair with seat plate 17 inches from the floor. Patients rise from this position with hands placed on opposite shoulders. If the patient must use his/her arms to stand, the test is stopped. If the patient is over halfway to a standing position when 30 seconds have lapsed, this counts as a stand.

Bioimpedance Spectroscopy

Bioimpedance spectroscopy (BIS) is a reliable, responsive measure of swelling that has been validated in observational studies of individuals after TKA. The RJL Systems Quantum® (Clinton Township, MI) bioelectrical impedance device delivers a 2.5 µA alternating current at a frequency of 50 kHz. The tissue impedance to this current is displayed in Ohms (Ω) and is recorded at a precision of 1 Ω. The level of impedance met by the current reflects the composition of the tissue, but will also fluctuate with the presence of swelling in the lower extremity. Lower levels of impedance represent the increased fluid content present with greater levels of swelling. Measuring the impedance of both the involved and uninvolved limb allows for calculation of a ratio (W-involved limb: W-uninvolved limb). To measure impedance, a four-wire measurement method will be used. The most proximal electrode pair will be placed 10 and 20 centimeters above the superior patellar pole. The most distal electrode pair will be placed at a point bisecting the medial and lateral malleolus, and also 10 cm distal to that point along the second ray of the foot. New electrodes will be used for each testing session, and skin will be cleaned with an alcohol swab prior to electrode placement.