Comparison of Maxillary Canine Retraction Rate With and Without Power Arm

September 22, 2026 updated by: Tanzila Rafique

Comparison of Maxillary Canine Retraction Rate With and Without Power Arm: A Split-Mouth Randomized Control Trial

The goal of this split-mouth randomized clinical trial is to compare maxillary canine retraction with and without power arm during fixed orthodontic treatment.The main question it aims to answer is What are the differences in the rate of maxillary canine retraction between the power- arm technique and the direct sliding technique over a 6-month period time?

Study Overview

Status

Enrolling by invitation

Conditions

Intervention / Treatment

Detailed Description

Researchers will compare a power arm placed in the vertical slot of the canine bracket with elastomeric chain to a mini-screw (experimental/PAS) against a conventional elastomeric chain from the canine bracket directly to a mini-screw (control/DS) during canine retraction phase.

Participants will:

  • undergo bilateral maxillary first premolar extractions, followed by placement of a titanium mini-screw or TAD (Vector TAS, 1.4×8.0 mm) between second premolar and first molar on each side for anchorage.
  • receive fixed orthodontic treatment using a pre-adjusted edgewise appliance system (Roth, 0.018-inch slot).
  • have levelling and alignment carried out using a graduated arch-wire sequence (0.014-inch, 0.016-inch, 0.016×0.016-inch, 0.016×0.022-inch, and 0.017×0.025-inch), with angulation corrections addressed at this stage.
  • have bilateral canine retraction initiated three months post-extraction on a 0.016×0.022-inch stainless steel arch-wire, with an elastomeric chain attaching from the power arm to the mini-screw on the experimental (PAS) side and directly from the canine bracket to the mini-screw on the control (DS) side, under a standardized force of 150g reactivated every 21 days.
  • be evaluated via CBCT at baseline (T0) and at 3 and 6 months (T1, T2) to measure canine retraction rate and angulation change on both sides

Study Type

Interventional

Enrollment (Estimated)

28

Phase

  • Not Applicable

Contacts and Locations

This section provides the contact details for those conducting the study, and information on where this study is being conducted.

Study Locations

      • Dhaka, Bangladesh, 1215
        • Bangladesh Medical University (BMU), Dhaka,1000

Participation Criteria

Researchers look for people who fit a certain description, called eligibility criteria. Some examples of these criteria are a person's general health condition or prior treatments.

Eligibility Criteria

Ages Eligible for Study

18 years to 25 years (Adult)

Accepts Healthy Volunteers

Yes

Genders Eligible for Study

All

Description

Inclusion Criteria:

  • Participant with Angle's class I and class II malocclusion who required both maxillary bilateral premolar extraction for orthodontic treatment.
  • Participants who required maximum anchorage.
  • Participants with good general health condition and oral hygiene status.
  • Age range of the participants will be 18 to 25 years.
  • Sex of the participants will be both male and female.
  • Participants with full permanent dentition present (excluding 3 rd molar).
  • Participants who have completed the levelling and alignment phase before the start of canine retraction.
  • Participants with no caries, fracture, periapical lesion, root resorption, morphological variation or other pathology involving the maxillary canine.

Exclusion Criteria:

  • Participants with systemic conditions affecting bone metabolism or orthodontic tooth movement (e.g., diabetes mellitus, osteoporosis).
  • Participants with impacted or displaced maxillary canines.
  • Participants with retained deciduous canines.
  • Participants with dental anomalies affecting canine retraction.
  • Participants with previous orthodontic treatment.
  • Participants with cleft lip/palate, craniofacial syndromes, or facial asymmetry.
  • Participants requiring surgical orthodontic treatment.
  • Pregnant women.
  • Participants with poor cooperation, missed appointments, or frequent appliance breakage.
  • Habit of smoking.

Study Plan

This section provides details of the study plan, including how the study is designed and what the study is measuring.

How is the study designed?

Design Details

  • Primary Purpose: Treatment
  • Allocation: Randomized
  • Interventional Model: Parallel Assignment
  • Masking: None (Open Label)

Arms and Interventions

Participant Group / Arm
Intervention / Treatment
Experimental: Power Arm sliding technique

Experimental: Power Arm sliding techniqueA power arm placed in the vertical slot of the canine bracket and elastomeric chain attached from power arm to mini-screw.

Experimental: Power Arm sliding technique: A power arm placed in the vertical slot of the canine bracket and elastomeric chain attached from power arm to mini-screw.

Active Comparator / Control: direct sliding technique:

Elastomeric chain applied directly from the canine bracket to a mini-screw on the contralateral side.

Other Names:
  • Experimental: Power Arm sliding technique
  • Active Comparator / Control: direct sliding technique
Active Comparator: Control: direct sliding technique

Active Comparator / Control: direct sliding technique: Elastomeric chain applied directly from the canine bracket to a mini-screw on the contralateral side.

Experimental: Power Arm sliding technique: A power arm placed in the vertical slot of the canine bracket and elastomeric chain attached from power arm to mini-screw.

Active Comparator / Control: direct sliding technique:

Elastomeric chain applied directly from the canine bracket to a mini-screw on the contralateral side.

Other Names:
  • Experimental: Power Arm sliding technique
  • Active Comparator / Control: direct sliding technique

What is the study measuring?

Primary Outcome Measures

Outcome Measure
Measure Description
Time Frame
Primary outcome measure
Time Frame: 6 months

This split-mouth randomized clinical trial will compare maxillary canine retraction (in mm) with and without a power arm during fixed orthodontic treatment.

6 months

Secondary Outcome Measures

Outcome Measure
Measure Description
Time Frame
Secondary outcome measures
Time Frame: 6 months
  • Participants will receive fixed orthodontic treatment using a pre-adjusted edgewise appliance system (Roth, 0.018-inch slot).
  • Bilateral maxillary first premolar extractions will be done followed by placement of a titanium mini-screw or TAD (Vector TAS, 1.4×8.0 mm) between the second premolar and first molar on each side.
  • Levelling and alignment will be carriedout using a graduated arch-wire sequence (0.014-inch, 0.016-inch, 0.016×0.016-inch, 0.016×0.022-inch, and 0.017×0.025-inch).
  • Bilateral canine retraction will be initiated three months post-extraction on a 0.016×0.022-inch stainless steel arch-wire, with an elastomeric chain attaching from the power arm to the mini-screw on the experimental (PAS) side and directly from the canine bracket to the mini-screw on the control (DS) side, under a force of 150g reactivated every 21 days.
  • Evaluation will be done at 3 and 6 months to measure canine retraction rate (in mm) and angulation changes(in degrees) at both side.
6 months

Collaborators and Investigators

This is where you will find people and organizations involved with this study.

Sponsor

Investigators

  • Study Director: Mahmood Sajedeen, BDS,FCPS, Bangladesh Medical University (BMU)
  • Study Director: Sajedeen, Bangladesh Medical University (BMU), Dhaka-1000

Study record dates

These dates track the progress of study record and summary results submissions to ClinicalTrials.gov. Study records and reported results are reviewed by the National Library of Medicine (NLM) to make sure they meet specific quality control standards before being posted on the public website.

Study Major Dates

Study Start (Actual)

August 18, 2026

Primary Completion (Estimated)

August 17, 2027

Study Completion (Estimated)

August 17, 2027

Study Registration Dates

First Submitted

September 3, 2026

First Submitted That Met QC Criteria

September 17, 2026

First Posted (Actual)

September 23, 2026

Study Record Updates

Last Update Posted (Actual)

September 24, 2026

Last Update Submitted That Met QC Criteria

September 22, 2026

Last Verified

September 1, 2026

More Information

Terms related to this study

Other Study ID Numbers

  • BMU/2026/8639

Plan for Individual participant data (IPD)

Plan to Share Individual Participant Data (IPD)?

NO

Drug and device information, study documents

Studies a U.S. FDA-regulated drug product

No

Studies a U.S. FDA-regulated device product

No

This information was retrieved directly from the website clinicaltrials.gov without any changes. If you have any requests to change, remove or update your study details, please contact register@clinicaltrials.gov. As soon as a change is implemented on clinicaltrials.gov, this will be updated automatically on our website as well.