Ta strona została przetłumaczona automatycznie i dokładność tłumaczenia nie jest gwarantowana. Proszę odnieść się do angielska wersja za tekst źródłowy.

Comparison of Maxillary Canine Retraction Rate With and Without Power Arm

22 września 2026 zaktualizowane przez: Tanzila Rafique

Comparison of Maxillary Canine Retraction Rate With and Without Power Arm: A Split-Mouth Randomized Control Trial

The goal of this split-mouth randomized clinical trial is to compare maxillary canine retraction with and without power arm during fixed orthodontic treatment.The main question it aims to answer is What are the differences in the rate of maxillary canine retraction between the power- arm technique and the direct sliding technique over a 6-month period time?

Przegląd badań

Status

Rejestracja na zaproszenie

Warunki

Interwencja / Leczenie

Szczegółowy opis

Researchers will compare a power arm placed in the vertical slot of the canine bracket with elastomeric chain to a mini-screw (experimental/PAS) against a conventional elastomeric chain from the canine bracket directly to a mini-screw (control/DS) during canine retraction phase.

Participants will:

  • undergo bilateral maxillary first premolar extractions, followed by placement of a titanium mini-screw or TAD (Vector TAS, 1.4×8.0 mm) between second premolar and first molar on each side for anchorage.
  • receive fixed orthodontic treatment using a pre-adjusted edgewise appliance system (Roth, 0.018-inch slot).
  • have levelling and alignment carried out using a graduated arch-wire sequence (0.014-inch, 0.016-inch, 0.016×0.016-inch, 0.016×0.022-inch, and 0.017×0.025-inch), with angulation corrections addressed at this stage.
  • have bilateral canine retraction initiated three months post-extraction on a 0.016×0.022-inch stainless steel arch-wire, with an elastomeric chain attaching from the power arm to the mini-screw on the experimental (PAS) side and directly from the canine bracket to the mini-screw on the control (DS) side, under a standardized force of 150g reactivated every 21 days.
  • be evaluated via CBCT at baseline (T0) and at 3 and 6 months (T1, T2) to measure canine retraction rate and angulation change on both sides

Typ studiów

Interwencyjne

Zapisy (Szacowany)

28

Faza

  • Nie dotyczy

Kontakty i lokalizacje

Ta sekcja zawiera dane kontaktowe osób prowadzących badanie oraz informacje o tym, gdzie badanie jest przeprowadzane.

Lokalizacje studiów

      • Dhaka, Bangladesz, 1215
        • Bangladesh Medical University (BMU), Dhaka,1000

Kryteria uczestnictwa

Badacze szukają osób, które pasują do określonego opisu, zwanego kryteriami kwalifikacyjnymi. Niektóre przykłady tych kryteriów to ogólny stan zdrowia danej osoby lub wcześniejsze leczenie.

Kryteria kwalifikacji

Wiek uprawniający do nauki

18 lat do 25 lat (Dorosły)

Akceptuje zdrowych ochotników

Tak

Płeć kwalifikująca się do nauki

Wszystko

Opis

Inclusion Criteria:

  • Participant with Angle's class I and class II malocclusion who required both maxillary bilateral premolar extraction for orthodontic treatment.
  • Participants who required maximum anchorage.
  • Participants with good general health condition and oral hygiene status.
  • Age range of the participants will be 18 to 25 years.
  • Sex of the participants will be both male and female.
  • Participants with full permanent dentition present (excluding 3 rd molar).
  • Participants who have completed the levelling and alignment phase before the start of canine retraction.
  • Participants with no caries, fracture, periapical lesion, root resorption, morphological variation or other pathology involving the maxillary canine.

Exclusion Criteria:

  • Participants with systemic conditions affecting bone metabolism or orthodontic tooth movement (e.g., diabetes mellitus, osteoporosis).
  • Participants with impacted or displaced maxillary canines.
  • Participants with retained deciduous canines.
  • Participants with dental anomalies affecting canine retraction.
  • Participants with previous orthodontic treatment.
  • Participants with cleft lip/palate, craniofacial syndromes, or facial asymmetry.
  • Participants requiring surgical orthodontic treatment.
  • Pregnant women.
  • Participants with poor cooperation, missed appointments, or frequent appliance breakage.
  • Habit of smoking.

Plan studiów

Ta sekcja zawiera szczegółowe informacje na temat planu badania, w tym sposób zaprojektowania badania i jego pomiary.

Jak projektuje się badanie?

Szczegóły projektu

  • Główny cel: Leczenie
  • Przydział: Randomizowane
  • Model interwencyjny: Przydział równoległy
  • Maskowanie: Brak (otwarta etykieta)

Broń i interwencje

Grupa uczestników / Arm
Interwencja / Leczenie
Eksperymentalny: Power Arm sliding technique

Experimental: Power Arm sliding techniqueA power arm placed in the vertical slot of the canine bracket and elastomeric chain attached from power arm to mini-screw.

Experimental: Power Arm sliding technique: A power arm placed in the vertical slot of the canine bracket and elastomeric chain attached from power arm to mini-screw.

Active Comparator / Control: direct sliding technique:

Elastomeric chain applied directly from the canine bracket to a mini-screw on the contralateral side.

Inne nazwy:
  • Experimental: Power Arm sliding technique
  • Active Comparator / Control: direct sliding technique
Aktywny komparator: Control: direct sliding technique

Active Comparator / Control: direct sliding technique: Elastomeric chain applied directly from the canine bracket to a mini-screw on the contralateral side.

Experimental: Power Arm sliding technique: A power arm placed in the vertical slot of the canine bracket and elastomeric chain attached from power arm to mini-screw.

Active Comparator / Control: direct sliding technique:

Elastomeric chain applied directly from the canine bracket to a mini-screw on the contralateral side.

Inne nazwy:
  • Experimental: Power Arm sliding technique
  • Active Comparator / Control: direct sliding technique

Co mierzy badanie?

Podstawowe miary wyniku

Miara wyniku
Opis środka
Ramy czasowe
Primary outcome measure
Ramy czasowe: 6 months

This split-mouth randomized clinical trial will compare maxillary canine retraction (in mm) with and without a power arm during fixed orthodontic treatment.

6 months

Miary wyników drugorzędnych

Miara wyniku
Opis środka
Ramy czasowe
Secondary outcome measures
Ramy czasowe: 6 months
  • Participants will receive fixed orthodontic treatment using a pre-adjusted edgewise appliance system (Roth, 0.018-inch slot).
  • Bilateral maxillary first premolar extractions will be done followed by placement of a titanium mini-screw or TAD (Vector TAS, 1.4×8.0 mm) between the second premolar and first molar on each side.
  • Levelling and alignment will be carriedout using a graduated arch-wire sequence (0.014-inch, 0.016-inch, 0.016×0.016-inch, 0.016×0.022-inch, and 0.017×0.025-inch).
  • Bilateral canine retraction will be initiated three months post-extraction on a 0.016×0.022-inch stainless steel arch-wire, with an elastomeric chain attaching from the power arm to the mini-screw on the experimental (PAS) side and directly from the canine bracket to the mini-screw on the control (DS) side, under a force of 150g reactivated every 21 days.
  • Evaluation will be done at 3 and 6 months to measure canine retraction rate (in mm) and angulation changes(in degrees) at both side.
6 months

Współpracownicy i badacze

Tutaj znajdziesz osoby i organizacje zaangażowane w to badanie.

Sponsor

Śledczy

  • Dyrektor Studium: Mahmood Sajedeen, BDS,FCPS, Bangladesh Medical University (BMU)
  • Dyrektor Studium: Sajedeen, Bangladesh Medical University (BMU), Dhaka-1000

Daty zapisu na studia

Daty te śledzą postęp w przesyłaniu rekordów badań i podsumowań wyników do ClinicalTrials.gov. Zapisy badań i zgłoszone wyniki są przeglądane przez National Library of Medicine (NLM), aby upewnić się, że spełniają określone standardy kontroli jakości, zanim zostaną opublikowane na publicznej stronie internetowej.

Główne daty studiów

Rozpoczęcie studiów (Rzeczywisty)

18 sierpnia 2026

Zakończenie podstawowe (Szacowany)

17 sierpnia 2027

Ukończenie studiów (Szacowany)

17 sierpnia 2027

Daty rejestracji na studia

Pierwszy przesłany

3 września 2026

Pierwszy przesłany, który spełnia kryteria kontroli jakości

17 września 2026

Pierwszy wysłany (Rzeczywisty)

23 września 2026

Aktualizacje rekordów badań

Ostatnia wysłana aktualizacja (Rzeczywisty)

24 września 2026

Ostatnia przesłana aktualizacja, która spełniała kryteria kontroli jakości

22 września 2026

Ostatnia weryfikacja

1 września 2026

Więcej informacji

Terminy związane z tym badaniem

Inne numery identyfikacyjne badania

  • BMU/2026/8639

Plan dla danych uczestnika indywidualnego (IPD)

Planujesz udostępniać dane poszczególnych uczestników (IPD)?

NIE

Informacje o lekach i urządzeniach, dokumenty badawcze

Bada produkt leczniczy regulowany przez amerykańską FDA

Nie

Bada produkt urządzenia regulowany przez amerykańską FDA

Nie

Te informacje zostały pobrane bezpośrednio ze strony internetowej clinicaltrials.gov bez żadnych zmian. Jeśli chcesz zmienić, usunąć lub zaktualizować dane swojego badania, skontaktuj się z register@clinicaltrials.gov. Gdy tylko zmiana zostanie wprowadzona na stronie clinicaltrials.gov, zostanie ona automatycznie zaktualizowana również na naszej stronie internetowej .