Effect of Different Adhesive Removal Techniques After Orthodontic Bracket Debonding on Postoperative Hypersensitivity: A Randomized Clinical Trial
The objective of this randomized clinical trial is to evaluate and compare the effect of four different residual adhesive removal techniques following orthodontic bracket debonding on postoperative tooth hypersensitivity. The study compares low-speed tungsten carbide burs against fiberglass burs, white stone burs, and rubber-impregnated polishing points. Postoperative hypersensitivity will be evaluated using a Visual Analogue Scale (VAS) with an air-blast stimulus test immediately after debonding, at 24 hours, and at 7 days follow-up.
Studieoversigt
Status
Status
Betingelser
Betingelser
Intervention / Behandling
Intervention / Behandling
Undersøgelsestype
Undersøgelsestype
Tilmelding (Anslået)
Tilmelding
Fase
Fase
- Ikke anvendelig
Kontakter og lokationer
Studiekontakt
Studiekontakt
- Navn: Asmaa Badr Abdelfatah, BDS
- Telefonnummer: +20 1148106593
- E-mail: asmaa.abdelfatah@dentistry.cu.edu.eg
Undersøgelse Kontakt Backup
- Navn: Heba El-Deeb, PhD
- Telefonnummer: +20 106 610 9461
- E-mail: heba.eldeeb@dentistry.cu.edu.eg
Studiesteder
-
-
-
Cairo, Egypten
- Faculty of Dentistry, Cairo University
-
-
Deltagelseskriterier
Berettigelseskriterier
Berettigelseskriterier
Aldre berettiget til at studere
Tager imod sunde frivillige
Køn, der er berettiget til at studere
Beskrivelse
Inclusion Criteria:
- Patients of any gender aged 15 to 45 years undergoing routine fixed labial orthodontic bracket removal across anterior and premolar teeth in both jaws.
- Systemically healthy patients.
- Good oral hygiene with a healthy, intact periodontium without clinical attachment loss or gingival recession.
- Patients capable of reliably recording subjective discomfort on a Visual Analogue Scale (VAS) and willing to attend follow-up visits.
- Sound fully erupted permanent incisors, canines, and premolars bonded with conventional stainless steel labial brackets.
- Labial enamel surfaces free of visible pre-existing enamel defects, structural hypoplasia, severe fluorosis, or restorations.
Exclusion Criteria:
- Active use of systemic analgesics, NSAIDs, corticosteroids, or centrally acting pain medications within 14 days prior to debonding.
- Use of desensitizing toothpastes, mouthwashes, or topical fluoride varnishes within 30 days prior to the trial.
- Heavy bruxism, clenching habits, or pathological wear/erosion extending into dentin.
- Pregnant or lactating female patients.
- Teeth with irreversible pulpitis, pulpal necrosis, history of endodontic treatment, or periapical pathology.
- Teeth with active carious lesions or exposed cervical dentin/cementum.
- Teeth with severe, deep enamel microcracks identified at baseline examination.
Studieplan
Hvordan er undersøgelsen tilrettelagt?
Design detaljer
- Primært formål: Behandling
- Tildeling: Randomiseret
- Interventionel model: Parallel tildeling
- Maskning: Dobbelt
Antal våben
Våben og indgreb
Deltagergruppe / ArmDeltagergruppe / Arm |
Intervention / BehandlingIntervention / Behandling |
|---|---|
|
Aktiv komparator: Active Comparator: Low-Speed Tungsten Carbide Bur
Residual composite adhesive remnants on eligible teeth are cleaned using a 12-fluted low-speed tungsten carbide bur operated at 15,000-20,000 rpm under continuous water cooling. |
Composite resin is removed using a 12-fluted tapered low-speed tungsten carbide bur operated at 15,000-20,000 rpm under continuous air-water spray irrigation until all visible adhesive remnant is completely eliminated. |
|
Eksperimentel: Fiberglass Bur
Residual composite adhesive remnants on eligible teeth are cleaned using a fiberglass bur operated at 15,000-20,000 rpm under continuous water cooling |
Composite resin remnants are eliminated using a fiberglass resin-removal bur operated at 15,000-20,000 rpm under continuous air-water spray irrigation until all visible material is completely removed. |
|
Eksperimentel: White Stone Bur
Residual composite adhesive remnants on eligible teeth are cleaned using a fine-grit white stone bur (aluminum oxide) operated at 10,000-15,000 rpm under continuous water cooling. |
Composite resin remnants are removed using a fine-grit Arkansas white stone bur (aluminum oxide) operated at 10,000-15,000 rpm under continuous air-water spray irrigation until the enamel surface is clear. |
|
Eksperimentel: Rubber-Impregnated Polishing Point
Residual composite adhesive remnants on eligible teeth are cleaned using a rubber-impregnated polishing point operated at 10,000-15,000 rpm under continuous water cooling |
Residual adhesive tags are removed and polished using a rubber-impregnated composite polishing point operated at 10,000-15,000 rpm under continuous air-water spray irrigation |
Hvad måler undersøgelsen?
Primære resultatmål
Primære resultatmål
Resultatmål |
Foranstaltningsbeskrivelse |
Tidsramme |
|---|---|---|
|
Postoperative Hypersensitivity
Tidsramme: Baseline (immediately post-debonding, before clean-up), 24 hours, and 7 days post-adhesive removal.
|
Patient-reported pain and hypersensitivity evaluated using a Visual Analogue Scale (VAS) score ranging from 0 (No pain) to 10 (Unbearable severe pain) in response to a 2-second dental syringe air-blast stimulus test. |
Baseline (immediately post-debonding, before clean-up), 24 hours, and 7 days post-adhesive removal.
|
Sekundære resultatmål
Sekundære resultatmål
Resultatmål |
Foranstaltningsbeskrivelse |
Tidsramme |
|---|---|---|
|
Procedure Time
Tidsramme: Immediately during the clean-up procedure.
|
Time taken to perform complete residual adhesive removal per tooth, measured using a stopwatch |
Immediately during the clean-up procedure.
|
Samarbejdspartnere og efterforskere
Sponsor
Sponsor
Efterforskere
Efterforskere
- Studieleder: Heba El-Deeb, PhD, Cairo to Department of Conservative Dentistry, Faculty of Dentistry, Cairo University .
Datoer for undersøgelser
Studer store datoer
Studiestart (Anslået)
Studiestart
Primær færdiggørelse (Anslået)
Primær færdiggørelse
Studieafslutning (Anslået)
Studieafslutning
Datoer for studieregistrering
Først indsendt
Først indsendt
Først indsendt, der opfyldte QC-kriterier
Først indsendt, der opfyldte QC-kriterier
Først opslået (Faktiske)
Først opslået
Opdateringer af undersøgelsesjournaler
Sidste opdatering sendt (Faktiske)
Sidste opdatering sendt
Sidste opdatering indsendt, der opfyldte kvalitetskontrolkriterier
Sidste opdatering indsendt, der opfyldte kvalitetskontrolkriterier
Sidst verificeret
Sidst verificeret
Mere information
Begreber relateret til denne undersøgelse
Yderligere relevante MeSH-vilkår
Andre undersøgelses-id-numre
Andre undersøgelses-id-numre
- CONS 3-4-1
Plan for individuelle deltagerdata (IPD)
Planlægger du at dele individuelle deltagerdata (IPD)?
Lægemiddel- og udstyrsoplysninger, undersøgelsesdokumenter
Studerer et amerikansk FDA-reguleret lægemiddelprodukt
Studerer et amerikansk FDA-reguleret enhedsprodukt
Disse oplysninger blev hentet direkte fra webstedet clinicaltrials.gov uden ændringer. Hvis du har nogen anmodninger om at ændre, fjerne eller opdatere dine undersøgelsesoplysninger, bedes du kontakte register@clinicaltrials.gov. Så snart en ændring er implementeret på clinicaltrials.gov, vil denne også blive opdateret automatisk på vores hjemmeside .