Ta strona została przetłumaczona automatycznie i dokładność tłumaczenia nie jest gwarantowana. Proszę odnieść się do angielska wersja za tekst źródłowy.

Effect of Different Adhesive Removal Techniques After Orthodontic Bracket Debonding on Postoperative Hypersensitivity: A Randomized Clinical Trial

9 listopada 2026 zaktualizowane przez: Asmaa Badr Abdelfatah

The objective of this randomized clinical trial is to evaluate and compare the effect of four different residual adhesive removal techniques following orthodontic bracket debonding on postoperative tooth hypersensitivity. The study compares low-speed tungsten carbide burs against fiberglass burs, white stone burs, and rubber-impregnated polishing points. Postoperative hypersensitivity will be evaluated using a Visual Analogue Scale (VAS) with an air-blast stimulus test immediately after debonding, at 24 hours, and at 7 days follow-up.

Przegląd badań

Status

Jeszcze nie rekrutacja

Warunki

Interwencja / Leczenie

Typ studiów

Interwencyjne

Zapisy (Szacowany)

15

Faza

  • Nie dotyczy

Kontakty i lokalizacje

Ta sekcja zawiera dane kontaktowe osób prowadzących badanie oraz informacje o tym, gdzie badanie jest przeprowadzane.

Kontakt w sprawie studiów

Kopia zapasowa kontaktu do badania

Lokalizacje studiów

      • Cairo, Egipt
        • Faculty of Dentistry, Cairo University

Kryteria uczestnictwa

Badacze szukają osób, które pasują do określonego opisu, zwanego kryteriami kwalifikacyjnymi. Niektóre przykłady tych kryteriów to ogólny stan zdrowia danej osoby lub wcześniejsze leczenie.

Kryteria kwalifikacji

Wiek uprawniający do nauki

15 lat do 45 lat (Dziecko, Dorosły)

Akceptuje zdrowych ochotników

Tak

Płeć kwalifikująca się do nauki

Wszystko

Opis

Inclusion Criteria:

  • Patients of any gender aged 15 to 45 years undergoing routine fixed labial orthodontic bracket removal across anterior and premolar teeth in both jaws.
  • Systemically healthy patients.
  • Good oral hygiene with a healthy, intact periodontium without clinical attachment loss or gingival recession.
  • Patients capable of reliably recording subjective discomfort on a Visual Analogue Scale (VAS) and willing to attend follow-up visits.
  • Sound fully erupted permanent incisors, canines, and premolars bonded with conventional stainless steel labial brackets.
  • Labial enamel surfaces free of visible pre-existing enamel defects, structural hypoplasia, severe fluorosis, or restorations.

Exclusion Criteria:

  • Active use of systemic analgesics, NSAIDs, corticosteroids, or centrally acting pain medications within 14 days prior to debonding.
  • Use of desensitizing toothpastes, mouthwashes, or topical fluoride varnishes within 30 days prior to the trial.
  • Heavy bruxism, clenching habits, or pathological wear/erosion extending into dentin.
  • Pregnant or lactating female patients.
  • Teeth with irreversible pulpitis, pulpal necrosis, history of endodontic treatment, or periapical pathology.
  • Teeth with active carious lesions or exposed cervical dentin/cementum.
  • Teeth with severe, deep enamel microcracks identified at baseline examination.

Plan studiów

Ta sekcja zawiera szczegółowe informacje na temat planu badania, w tym sposób zaprojektowania badania i jego pomiary.

Jak projektuje się badanie?

Szczegóły projektu

  • Główny cel: Leczenie
  • Przydział: Randomizowane
  • Model interwencyjny: Przydział równoległy
  • Maskowanie: Podwójnie

Broń i interwencje

Grupa uczestników / Arm
Interwencja / Leczenie
Aktywny komparator: Active Comparator: Low-Speed Tungsten Carbide Bur

Residual composite adhesive remnants on eligible teeth are cleaned using a 12-fluted low-speed tungsten carbide bur operated at 15,000-20,000 rpm under continuous water cooling.

Composite resin is removed using a 12-fluted tapered low-speed tungsten carbide bur operated at 15,000-20,000 rpm under continuous air-water spray irrigation until all visible adhesive remnant is completely eliminated.

Eksperymentalny: Fiberglass Bur

Residual composite adhesive remnants on eligible teeth are cleaned using a fiberglass bur operated at 15,000-20,000 rpm under continuous water cooling

Composite resin remnants are eliminated using a fiberglass resin-removal bur operated at 15,000-20,000 rpm under continuous air-water spray irrigation until all visible material is completely removed.

Eksperymentalny: White Stone Bur

Residual composite adhesive remnants on eligible teeth are cleaned using a fine-grit white stone bur (aluminum oxide) operated at 10,000-15,000 rpm under continuous water cooling.

Composite resin remnants are removed using a fine-grit Arkansas white stone bur (aluminum oxide) operated at 10,000-15,000 rpm under continuous air-water spray irrigation until the enamel surface is clear.

Eksperymentalny: Rubber-Impregnated Polishing Point

Residual composite adhesive remnants on eligible teeth are cleaned using a rubber-impregnated polishing point operated at 10,000-15,000 rpm under continuous water cooling

Residual adhesive tags are removed and polished using a rubber-impregnated composite polishing point operated at 10,000-15,000 rpm under continuous air-water spray irrigation

Co mierzy badanie?

Podstawowe miary wyniku

Miara wyniku
Opis środka
Ramy czasowe
Postoperative Hypersensitivity
Ramy czasowe: Baseline (immediately post-debonding, before clean-up), 24 hours, and 7 days post-adhesive removal.

Patient-reported pain and hypersensitivity evaluated using a Visual Analogue Scale (VAS) score ranging from 0 (No pain) to 10 (Unbearable severe pain) in response to a 2-second dental syringe air-blast stimulus test.

Baseline (immediately post-debonding, before clean-up), 24 hours, and 7 days post-adhesive removal.

Miary wyników drugorzędnych

Miara wyniku
Opis środka
Ramy czasowe
Procedure Time
Ramy czasowe: Immediately during the clean-up procedure.

Time taken to perform complete residual adhesive removal per tooth, measured using a stopwatch

Immediately during the clean-up procedure.

Współpracownicy i badacze

Tutaj znajdziesz osoby i organizacje zaangażowane w to badanie.

Sponsor

Śledczy

  • Dyrektor Studium: Heba El-Deeb, PhD, Cairo to Department of Conservative Dentistry, Faculty of Dentistry, Cairo University .

Daty zapisu na studia

Daty te śledzą postęp w przesyłaniu rekordów badań i podsumowań wyników do ClinicalTrials.gov. Zapisy badań i zgłoszone wyniki są przeglądane przez National Library of Medicine (NLM), aby upewnić się, że spełniają określone standardy kontroli jakości, zanim zostaną opublikowane na publicznej stronie internetowej.

Główne daty studiów

Rozpoczęcie studiów (Szacowany)

1 listopada 2026

Zakończenie podstawowe (Szacowany)

1 czerwca 2027

Ukończenie studiów (Szacowany)

1 października 2027

Daty rejestracji na studia

Pierwszy przesłany

9 listopada 2026

Pierwszy przesłany, który spełnia kryteria kontroli jakości

9 listopada 2026

Pierwszy wysłany (Rzeczywisty)

13 listopada 2026

Aktualizacje rekordów badań

Ostatnia wysłana aktualizacja (Rzeczywisty)

13 listopada 2026

Ostatnia przesłana aktualizacja, która spełniała kryteria kontroli jakości

9 listopada 2026

Ostatnia weryfikacja

1 listopada 2026

Więcej informacji

Terminy związane z tym badaniem

Inne numery identyfikacyjne badania

  • CONS 3-4-1

Plan dla danych uczestnika indywidualnego (IPD)

Planujesz udostępniać dane poszczególnych uczestników (IPD)?

NIE

Informacje o lekach i urządzeniach, dokumenty badawcze

Bada produkt leczniczy regulowany przez amerykańską FDA

Nie

Bada produkt urządzenia regulowany przez amerykańską FDA

Nie

Te informacje zostały pobrane bezpośrednio ze strony internetowej clinicaltrials.gov bez żadnych zmian. Jeśli chcesz zmienić, usunąć lub zaktualizować dane swojego badania, skontaktuj się z register@clinicaltrials.gov. Gdy tylko zmiana zostanie wprowadzona na stronie clinicaltrials.gov, zostanie ona automatycznie zaktualizowana również na naszej stronie internetowej .