- ICH GCP
- US Clinical Trials Registry
- Clinical Trial NCT05273424
Clinical Outcomes of Hemodialysis in Brazil (COHEBRA): a Prospective Cohort Study (COHEBRA)
Clinical Outcomes of Chronic Kidney Disease Patients on Hemodialysis in Brazil: A Prospective Cohort Study
Study Overview
Status
Conditions
Detailed Description
Evaluation of HRV. HRV measurement was performed using an electrocardiographic device (Wincardio@, Micromed). The registry was acquired for 20 min before, in the second hour, and immediately after a midweek HD session. Patients were in a supine position and breathed normally during the recording. Patients with unstable patterns of breath had their HRV recording postponed. The electrocardiographic device transmitted the R-R interval record to digital storage, which was subsequently analyzed in the time and frequency domains of HRV through CardioSeries@ 2.4 software. In the time domain, RMSSD and SDNN were acquired. In the frequency domain analysis, a tachogram was interpolated in a frequency of 4 Hertz and divided into periods of 256 points with 50% overlap. These signals were submitted to spectral analysis by fast Fourier transformation to obtain the total power of the spectrum. The LF band, representing sympathetic modulation, was between 0.02 and 0.15 Hz. The HF band, attributed to parasympathetic modulation, was between 0.15 and 0.40 Hz.
ACE gene typing. Blood samples were drawn and centrifugated. The leukocyte supernatant pellet was extracted and stored. ACE polymorphism was typed by PCR for DD, ID, and II genotypes. It used the following specific primers for DNA amplification: sense 5=-CTGGAGACCACTCCCATCCTTTCT-3= and antisense 5= GATGTGGCCATCACATTCGTAGA- 3=. Through these primers, it was possible to detect allele deletion and insertion. A confirmatory PCR was done for all samples with the DD genotype to increase the specificity of the genotyping using a pair of specific primers for insertions, i.e., an allele I amplifier. These primers were as follows: sense 5=-TGGGACCACAGCGCCCGCCACTAC-3= and antisense 5=-TCGCCAGCCCTACCATGCCCATAA-3=. The temperature protocol was programed in the thermocycler beginning at 95°C for 5 min and then 40 cycles of denaturation at 95°C for 45 s, annealing at 54°C for 1 min, and extension at 72°C for 30 s each and then at 5 min at 72°C to finish uncompleted chains.
Hydration status assessment. The patient's hydration status was evaluated before and after (up to 20 min) the studied HD session using a Body Composition Monitor (Fresenius), which uses multifrequency bioimpedance spectroscopy to determine the electrical resistances of total body water and extracellular water. Electrodes were attached to the hand and feet opposite to vascular access, with the patient in a supine position, and the measurement was done and stored in a digital format and analyzed with the Fluid Management Tool. The results were provided as overhydration (in liters), which represents the excess of water above reference levels according to the patient's sex and age.
Muscle thickness and echo intensity by ultrasound Patients were evaluated after one midweek dialysis session. They initially were instructed to stand with the legs and ~20 cm apart. The length of right thigh was measured from the superior iliac spine to the proximal border of the patella. Right and left circumferences were assessed at the midpoint of the thighs. At the same level on the anterior face of the thighs, skin was marked with a water-resistant pen. The quadriceps thickness was measured with the probe over these points, perpendicular to the long axis of the limb (cross-sectional image) and captured after proper visualization of the bone surface. The image was stored in device's hard disk for each of the two sites.
The images were analyzed later using the software ImageJ (National Institute of Health, USA, version 1.37) for both muscle thickness and echo intensity (EI). The thickness was measured as the perpendicular distance between the point just above the apex of the femur surface and the point just below the rectus femoris' superficial fascia obtained using the same software with the length function. The measurements were registered in millimeters and posteriorly converted to centimeters.
The EI analysis was performed after the selection of a record region that includes as much muscle as possible while avoiding surrounding fascia. The EI was then calculated from the selected region with gray-scale analysis using the standard histogram function and expressed in values between 0 and 255 (0 = black; 255 = white) (Radaelli et al., 2013; Wilhelm et al., 2014).
Functional capacity - six-minute walking test Functional capacity was measured using the 6-minute walk test (6MWT). This test is a submaximal effort test, affordable and easy to perform, in addition to be well established as representative of functional capacity in frail subjects. The 6-minute walk test shows a good correlation with the maximal oxygen uptake measure. The result of 6MWT in meters was multiplied by 100 and divided by the predicted distance for age. The result (percent of predicted distance walked by age) was used in analysis.
Muscle strength assessment Evaluation of muscle strength was performed using the static strength test of the legs, using a Crown® (Oswaldo Filizola Industry, São Paulo, Brazil) dynamometer. The measurement was repeated after a 1-minute interval. The mean of the two measurements was used in the analysis.
Study Type
Enrollment (Anticipated)
Contacts and Locations
Study Locations
-
-
RS
-
Pelotas, RS, Brazil, 96020-260
- Hospital Universitário São Francisco de Paula
-
-
Participation Criteria
Eligibility Criteria
Ages Eligible for Study
Accepts Healthy Volunteers
Genders Eligible for Study
Sampling Method
Study Population
Description
Inclusion Criteria:
- chronic kidney disease
- hemodialysis treatment for longer than 90 days
Exclusion Criteria:
- According to outcomes evaluated
Study Plan
How is the study designed?
Design Details
Cohorts and Interventions
Group / Cohort |
|---|
|
no groups
A cohort of CKD patients on hemodialysis
|
What is the study measuring?
Primary Outcome Measures
Outcome Measure |
Measure Description |
Time Frame |
|---|---|---|
|
survival
Time Frame: ten years
|
survival time
|
ten years
|
Secondary Outcome Measures
Outcome Measure |
Measure Description |
Time Frame |
|---|---|---|
|
hospital admission
Time Frame: ten years
|
hospital admission rate
|
ten years
|
Collaborators and Investigators
Sponsor
Collaborators
Study record dates
Study Major Dates
Study Start (Actual)
Primary Completion (Actual)
Study Completion (Anticipated)
Study Registration Dates
First Submitted
First Submitted That Met QC Criteria
First Posted (Actual)
Study Record Updates
Last Update Posted (Actual)
Last Update Submitted That Met QC Criteria
Last Verified
More Information
Terms related to this study
Additional Relevant MeSH Terms
Other Study ID Numbers
- COHEBRA
Plan for Individual participant data (IPD)
Plan to Share Individual Participant Data (IPD)?
Drug and device information, study documents
Studies a U.S. FDA-regulated drug product
Studies a U.S. FDA-regulated device product
This information was retrieved directly from the website clinicaltrials.gov without any changes. If you have any requests to change, remove or update your study details, please contact register@clinicaltrials.gov. As soon as a change is implemented on clinicaltrials.gov, this will be updated automatically on our website as well.