Ta strona została przetłumaczona automatycznie i dokładność tłumaczenia nie jest gwarantowana. Proszę odnieść się do angielska wersja za tekst źródłowy.

Guided Biofilm Therapy Versus Conventional Polishing for Tooth Re-Staining

28 sierpnia 2026 zaktualizowane przez: Mehmet Ali Tuna, Ataturk University

Guided Biofilm Therapy Versus Conventional Polishing for Extrinsic Tooth Re-Staining, Patient Comfort, and Procedure Time: A Randomized Split-Mouth Trial

This study compared Guided Biofilm Therapy with conventional polishing in adults with visible extrinsic tooth staining. Each participant received Guided Biofilm Therapy on one side of the mouth and conventional polishing on the other side.

The study evaluated whether the two methods differed in the amount of tooth re-staining after treatment, patient discomfort during the procedures, and total procedure time. Tooth color was measured with a spectrophotometer immediately after treatment, at 1 month, and at 2 months. Patient discomfort was recorded using a visual analog scale, and procedure time was measured with a stopwatch.

A total of 34 participants completed the study.

Przegląd badań

Status

Zakończony

Warunki

Interwencja / Leczenie

Szczegółowy opis

This randomized split-mouth clinical trial was conducted in adults with visible extrinsic tooth staining. The aim was to compare Guided Biofilm Therapy (GBT) with conventional polishing in terms of post-procedural extrinsic tooth re-staining, patient discomfort, and procedure time.

Each participant received both interventions. One side of the mouth was assigned to GBT and the contralateral side to conventional polishing. The right-left allocation of the interventions was determined by randomization, with the two allocation sequences equally distributed among participants.

In the GBT intervention, dental biofilm was first disclosed and then removed using an air-water-powder system with a low-abrasive erythritol-based powder. Supragingival ultrasonic instrumentation was performed where necessary. In the conventional polishing intervention, supragingival instrumentation was followed by mechanical polishing with a brush and polishing paste.

Tooth color was assessed using a SpectroShade Micro spectrophotometer and the CIELAB color system. Measurements were performed immediately after treatment at baseline (T0), at 1 month (T1), and at 2 months (T2). Color change between assessment periods was calculated using ΔE*ab values.

Patient-reported discomfort was assessed immediately after each half-mouth procedure using a visual analog scale. Total procedure time for each intervention was recorded with a stopwatch.

The primary outcome was color change from immediately after treatment to 2 months. Secondary outcomes included color change from immediately after treatment to 1 month, color change from 1 month to 2 months, patient discomfort, and procedure time.

A total of 34 participants completed all study visits and follow-up assessments.

Typ studiów

Interwencyjne

Zapisy (Rzeczywisty)

34

Faza

  • Nie dotyczy

Kontakty i lokalizacje

Ta sekcja zawiera dane kontaktowe osób prowadzących badanie oraz informacje o tym, gdzie badanie jest przeprowadzane.

Lokalizacje studiów

    • Erzurum
      • Erzurum, Erzurum, Turcja (Türkiye), 25080
        • Ataturk University

Kryteria uczestnictwa

Badacze szukają osób, które pasują do określonego opisu, zwanego kryteriami kwalifikacyjnymi. Niektóre przykłady tych kryteriów to ogólny stan zdrowia danej osoby lub wcześniejsze leczenie.

Kryteria kwalifikacji

Wiek uprawniający do nauki

  • Dorosły
  • Starszy dorosły

Akceptuje zdrowych ochotników

Tak

Opis

Inclusion Criteria:

  • Age over 18 years.
  • Willingness to participate in the study and provision of written informed consent.
  • Good general health with no systemic disease.
  • Clinical presence of extrinsic staining on tooth surfaces at a level warranting professional polishing.
  • Right-handed tooth brushing.
  • No professional dental cleaning within the previous 6 months.

Exclusion Criteria:

  • Age under 18 years.
  • Diagnosis of periodontitis.
  • Current smoking.
  • Antibiotic use within the previous 3 months.
  • Presence of acute periodontal disease.
  • Allergy to polishing powders, specifically erythritol.
  • Presence of a communicable disease.
  • Teeth to be measured with restorations, caries, excessive wear, or structural defects that could affect measurement.
  • Active orthodontic treatment.
  • Developmental or structural anomalies affecting enamel and potentially increasing susceptibility to extrinsic staining, including hypomineralization, amelogenesis imperfecta, or dentinogenesis imperfecta.
  • Severe dental crowding preventing standardized measurements.

Plan studiów

Ta sekcja zawiera szczegółowe informacje na temat planu badania, w tym sposób zaprojektowania badania i jego pomiary.

Jak projektuje się badanie?

Szczegóły projektu

  • Główny cel: Zapobieganie
  • Przydział: Randomizowane
  • Model interwencyjny: Zadanie krzyżowe
  • Maskowanie: Pojedynczy

Broń i interwencje

Grupa uczestników / Arm
Interwencja / Leczenie
Eksperymentalny: Sequence A: Right GBT / Left Conventional Polishing
Participants assigned to Sequence A received Guided Biofilm Therapy on the right half of the mouth and conventional polishing on the left half of the mouth. Both interventions were performed within the split-mouth study design.
Dental biofilm was first disclosed to guide treatment. Supragingival biofilm and extrinsic staining were then removed using an air-water-powder system with a low-abrasive erythritol-based powder. Supragingival ultrasonic instrumentation was performed where necessary, followed by final surface control.
Inne nazwy:
  • GBT
Supragingival instrumentation was performed as needed, followed by mechanical polishing with a prophylaxis brush and polishing paste at 2500 to 3000 rpm. The procedure was completed with final surface control.
Inne nazwy:
  • CONV
Eksperymentalny: Sequence B: Right Conventional Polishing / Left GBT
Participants assigned to Sequence B received conventional polishing on the right half of the mouth and Guided Biofilm Therapy on the left half of the mouth. Both interventions were performed within the split-mouth study design.
Dental biofilm was first disclosed to guide treatment. Supragingival biofilm and extrinsic staining were then removed using an air-water-powder system with a low-abrasive erythritol-based powder. Supragingival ultrasonic instrumentation was performed where necessary, followed by final surface control.
Inne nazwy:
  • GBT
Supragingival instrumentation was performed as needed, followed by mechanical polishing with a prophylaxis brush and polishing paste at 2500 to 3000 rpm. The procedure was completed with final surface control.
Inne nazwy:
  • CONV

Co mierzy badanie?

Podstawowe miary wyniku

Miara wyniku
Opis środka
Ramy czasowe
Change in Tooth Color From Immediately After Treatment to 2 Months Assessed by CIELAB ΔE*ab Using a SpectroShade Micro Spectrophotometer
Ramy czasowe: Immediately after treatment (Day 1) and at 2 months
Tooth color was measured using a SpectroShade Micro spectrophotometer according to the CIELAB color system. Color change between immediately after treatment (T0) and 2 months (T2) was calculated as ΔEab using the formula: ΔEab = [(ΔL*)² + (Δa*)² + (Δb*)²]^(1/2). ΔEab is a continuous color-difference measure, with 0 indicating no color difference and higher values indicating greater color change. Therefore, lower ΔEab values indicate greater color stability.
Immediately after treatment (Day 1) and at 2 months

Miary wyników drugorzędnych

Miara wyniku
Opis środka
Ramy czasowe
Change in Tooth Color From Immediately After Treatment to 1 Month Assessed by CIELAB ΔE*ab Using a SpectroShade Micro Spectrophotometer
Ramy czasowe: Immediately after treatment (Day 1) and at 1 month
Tooth color was measured using a SpectroShade Micro spectrophotometer according to the CIELAB color system. Color change between immediately after treatment (T0) and 1 month (T1) was calculated as ΔEab using the formula: ΔEab = [(ΔL*)² + (Δa*)² + (Δb*)²]^(1/2). ΔEab is a continuous color-difference measure, with 0 indicating no color difference and higher values indicating greater color change. Therefore, lower ΔEab values indicate greater color stability.
Immediately after treatment (Day 1) and at 1 month
Change in Tooth Color From 1 Month to 2 Months
Ramy czasowe: At 1 month and 2 months
Tooth color was measured using a SpectroShade Micro spectrophotometer according to the CIELAB color system. Color change between 1 month (M1) and 2 months (M2) was calculated as ΔE*ab using the formula: ΔE*ab = [(ΔL*)² + (Δa*)² + (Δb*)²]^(1/2). Lower ΔE*ab values indicate less color change.
At 1 month and 2 months
Patient-Reported Discomfort Assessed Using a 10-cm Visual Analog Scale
Ramy czasowe: Immediately after completion of each half-mouth intervention (Day 1)
Patient-reported discomfort was assessed immediately after each half-mouth procedure using a 10-cm visual analog scale ranging from 0 to 10, where 0 indicated no discomfort and 10 indicated unbearable discomfort. The score reflected the overall perception of pain or sensitivity, heat, pressure or vibration, and discomfort related to water spray or aerosol. Lower scores indicate greater patient comfort.
Immediately after completion of each half-mouth intervention (Day 1)
Total Procedure Time Measured Using a Digital Stopwatch
Ramy czasowe: Periprocedural
Total procedure time for each intervention was recorded using a digital stopwatch. Timing began with the first clinical step of the relevant intervention and ended after completion of the final surface check. Patient preparation, isolation, and oral hygiene instruction were excluded. Procedure time was recorded in minutes and seconds, with shorter times indicating greater procedural efficiency.
Periprocedural

Współpracownicy i badacze

Tutaj znajdziesz osoby i organizacje zaangażowane w to badanie.

Sponsor

Śledczy

  • Dyrektor Studium: Recep Orbak, DDS, PhD, Ataturk University

Daty zapisu na studia

Daty te śledzą postęp w przesyłaniu rekordów badań i podsumowań wyników do ClinicalTrials.gov. Zapisy badań i zgłoszone wyniki są przeglądane przez National Library of Medicine (NLM), aby upewnić się, że spełniają określone standardy kontroli jakości, zanim zostaną opublikowane na publicznej stronie internetowej.

Główne daty studiów

Rozpoczęcie studiów (Rzeczywisty)

5 stycznia 2026

Zakończenie podstawowe (Rzeczywisty)

1 czerwca 2026

Ukończenie studiów (Rzeczywisty)

8 czerwca 2026

Daty rejestracji na studia

Pierwszy przesłany

18 sierpnia 2026

Pierwszy przesłany, który spełnia kryteria kontroli jakości

28 sierpnia 2026

Pierwszy wysłany (Rzeczywisty)

2 września 2026

Aktualizacje rekordów badań

Ostatnia wysłana aktualizacja (Rzeczywisty)

2 września 2026

Ostatnia przesłana aktualizacja, która spełniała kryteria kontroli jakości

28 sierpnia 2026

Ostatnia weryfikacja

1 sierpnia 2026

Więcej informacji

Terminy związane z tym badaniem

Inne numery identyfikacyjne badania

  • 926

Plan dla danych uczestnika indywidualnego (IPD)

Planujesz udostępniać dane poszczególnych uczestników (IPD)?

TAK

Opis planu IPD

De-identified individual participant data underlying the results reported in the published article will be shared. These data may include participant-level demographic variables, treatment allocation, ΔE*ab color-change outcomes, visual analog scale scores, and procedure-time data necessary to reproduce the reported analyses.

Ramy czasowe udostępniania IPD

Data and supporting information will be available beginning 6 months after publication of the study results and will remain available for 5 years.

Kryteria dostępu do udostępniania IPD

Qualified researchers may request access from the corresponding author for scientifically justified research purposes. Requests should include a brief research proposal describing the purpose of the analysis and the data requested. Access will be considered following review of the proposed use and applicable ethical and confidentiality requirements. Only de-identified data relevant to the approved request will be shared electronically.

Typ informacji pomocniczych dotyczących udostępniania IPD

  • PROTOKÓŁ BADANIA

Informacje o lekach i urządzeniach, dokumenty badawcze

Bada produkt leczniczy regulowany przez amerykańską FDA

Nie

Bada produkt urządzenia regulowany przez amerykańską FDA

Nie

produkt wyprodukowany i wyeksportowany z USA

Nie

Te informacje zostały pobrane bezpośrednio ze strony internetowej clinicaltrials.gov bez żadnych zmian. Jeśli chcesz zmienić, usunąć lub zaktualizować dane swojego badania, skontaktuj się z register@clinicaltrials.gov. Gdy tylko zmiana zostanie wprowadzona na stronie clinicaltrials.gov, zostanie ona automatycznie zaktualizowana również na naszej stronie internetowej .